Garmin 320A Посібник з монтажу - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник з монтажу для Морське радіо Garmin 320A. Garmin 320A 37 сторінок. Garmin gtx 320 aviation-transponder: install guide
Також для Garmin 320A: Посібник пілота (8 сторінок)

Друкувати сторінку

1. B4 Gtx 320/320A Interconnect Wiring Diagram

Trim coax outer insulation back 0.50".

Trim braid (not center conductor or insulation) back 0.25".

Strip Insulation back 0.120".

Place the ferrule over the coax braid, flush against the coax outer insulation before performing the

next step if the outside diameter of the coax braid is smaller than the inside diameter of the center

connector sidewall opening.

Insert cable (center conductor, dielectric and shield braid) through the sidewall of the connector and

solder the center conductor to the center pin of the connector.

When using low loss cable it may be necessary to flatten the solid wire center conductor slightly so

it can fit the slot on the RF connector center pin. When soldering, avoid applying excess heat to the

connector body, and center conductor insulator.

Heat the outside of the connector sleeve and at the same time apply solder between the braid and the

sleeve. Continue to apply heat until the solder flows evenly.

Install 50

Insert connector cap and tack solder in two places.

Page 8

Rev L

Matching Bushing.

NOTE

GTX 320/320A Installation Manual

190-00133-01