Garmin GTX 320 Посібник з монтажу - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з монтажу для Морське радіо Garmin GTX 320. Garmin GTX 320 43 сторінки. Garmin gtx 320/320a transponder installation manual
Також для Garmin GTX 320: Посібник з технічного обслуговування (24 сторінок), Посібник пілота (4 сторінок), Посібник з монтажу (37 сторінок)

INSTALLATION OVERVIEW

This section provides the necessary information for installing the GTX 320/320A Transponders, and where

required, optional accessories. Installation of the GTX 320/320A Transponder should comply with the aircraft

Type Certificate (TC) or Supplemental Type Certificate (STC). Cabling will be fabricated by the installing

agency to fit each particular aircraft. The guidance of FAA advisory circulars AC 43.13-1B and AC 43.13-2A,

where applicable, may be found useful for accomplishing retro-fit installations that comply with FAA regulations.

This section contains interconnect diagrams, mounting dimensions, and information pertaining to installation.

Carefully unpack the equipment and make a visual inspection of the unit for evidence of damage incurred during

shipment. If the unit is damaged, notify the carrier and file a claim. To justify a claim, save the original shipping

container and all packing materials. Do not return the unit to Garmin until the carrier has authorized the claim.

Retain the original shipping containers for storage. If the original containers are not available, a separate

cardboard container should be prepared that is large enough to accommodate sufficient packing material to

prevent movement.

2.3.1 Location Considerations

The antenna (Garmin P/N 010-10160-00) should be well removed from any major protrusions, the

engine(s), propeller(s), and antenna masts. It should also be as far removed as practical from landing

gear doors, access doors, or other openings that could alter its radiation pattern.

The antenna should be mounted on the underside of the aircraft and in a vertical position (relative to

the position of the aircraft in level flight).

Avoid mounting the antenna within three feet of the ADF sense antenna or any other communication

antenna and six feet from the DME antenna.

To prevent RF interference, the antenna must be mounted a minimum distance of three feet from the

GTX 320/320A.

If the antenna is being installed on a composite aircraft, ground planes may be required. Conductive

wire mesh, radials, or thin aluminum sheets embedded in the composite material provide the proper

ground plane allowing the antenna pattern (gain) to be maximized for optimum transponder

performance.

2.3.2 Antenna Installation

Install the antenna according to the antenna manufacturer's instructions and FAA AC 43.13-2A.

GTX 320/320A Installation Manual

190-00133-01

NOTE

Page 2-1

Rev M