Garmin GTX GTX 330D Доповнення до Посібника пілота - Сторінка 14
Переглянути онлайн або завантажити pdf Доповнення до Посібника пілота для Морське радіо Garmin GTX GTX 330D. Garmin GTX GTX 330D 50 сторінок. Mode s transponder
Також для Garmin GTX GTX 330D: Доповнення до Посібника пілота (50 сторінок), Посібник пілота (13 сторінок), Посібник пілота (13 сторінок), Посібник з монтажу (49 сторінок)
Друкувати сторінку
Part One: Section 3
TIS Operational Procedures
Manual Override
The user can manually switch between standby
(STBY) and operating (OPER) mode of operation to
manually override automatic operation.
To place the display into operating mode from the
standby mode (to display TIS traffic):
1.
Turn the cursor on and highlight "STBY".
2.
Turn the small right knob to select
"OPER?".
Press ENT to confirm.
3.
To place the display into standby mode from
operating mode (to stop displaying TIS traffic):
1.
Turn the cursor on and highlight "OPER".
2.
Turn the small right knob to select "STBY?"
Press ENT to confirm.
3.
"DATA FAIL" Message
10
The 'NO DATA' message indicates that data
are not being received from the GTX 330.
NOTE: This may be a normal mode of opera-
tion in a dual transponder installation where
the GTX 330 with TIS is not the selected
Flight Procedures
Once the aircraft is airborne (determined by system
configuration at the time of installation) the system
switches from standby mode to operating mode. The
400W/500W Series unit displays OPER in the upper
right hand corner of the display and begins to display
traffic on the Traffic or Map Page.
The TIS Traffic Advisory (TA) should alert the crew
to use additional vigilance to identify the intruding
aircraft. Any time the traffic symbol becomes a yellow
circle or a voice warning is announced, conduct a
visual search for the intruder. If successful, maintain
visual contact to ensure safe operation. See Section 2:
Control and Display for a description of pilot responses
to TIS display messages.
After Landing
Once the aircraft is "ground-borne" (determined
by system configuration at the time of installation)
the system switches from operating mode to standby
mode. The 400W/500W Series unit displays "STBY".
As described previously, both the standby and operat-
ing modes can be manually overridden by the display
controls.
190-00356-30 Rev C
transponder.