Garmin VHF 300 Інструкція з монтажу Посібник з монтажу
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Морське радіо Garmin VHF 300. Garmin VHF 300 12 сторінок. Vhf 300 series
Друкувати сторінку
These installation instructions are for the following VHF radios and handsets:
Throughout these instructions, both the VHF 300 and the VHF 300i will be referred to as the VHF 300 series radio, or "the radio". The GHS 10
and the GHS 10i will be referred to as the GHS 10.
Compare the contents of this package with the packing list on the box. If any pieces are missing, contact your Garmin
Product Registration
Help us better support you by completing our online registration today. Go to http://my.garmin.com. Keep the original sales receipt, or a
photocopy, in a safe place.
Contact Garmin
Contact Garmin Product Support if you have any questions while using your VHF 300 series radio. In the USA, go to
www.garmin.com/support, or contact Garmin USA by phone at (913) 397.8200 or (800) 800.1020.
In the UK, contact Garmin (Europe) Ltd. by phone at 0808 2380000.
In Europe, go to
www.garmin.com/support
phone at +44 (0) 870.8501241.
Warnings and Safety Notices
Antenna Mounting and EME Exposure
The VHF 300 series radio generates and radiates radio frequency (RF) electromagnetic energy (EME). Failure to observe these guidelines may
expose persons to RF radiation absorption exceeding the maximum permissible exposure (MPE).
Garmin declares an MPE radius of 59 in. (1.5 m) for this system, which was determined using 25 watts output to an omni-directional 9 dBi gain
antenna. The antenna should be installed such that a distance of 59 in. (1.5 m) is maintained between the antenna and all persons.
WARNING: Radio operators with cardiac pacemakers, life-support machines, or electrical medical equipment should not be exposed to excessive
radio-frequency fields.
WARNING: Operate the device in accordance with the instructions supplied.
CAutIoN: Wear safety goggles and a dust mask when drilling, cutting, or sanding.
NotICe: The device complies with internationally recognized standards covering human exposure to electromagnetic fields from radio devices.
NotICe: Check with local authorities for any antenna or operational restrictions that may apply.
NotICe: To prevent possible damage to your radio, the antenna must be connected to the radio before transmitting. This ensures that the power output
to the antenna port dissipates properly when transmitting.
Needed Tools
•
Drill and drill bits
•
#2 Phillips screwdriver
•
3
/
in. (90 mm) hole saw (for installing the active speaker)
1
2
•
Waterproof, adhesive tape (such as rubber vulcanizing tape)
May 2010
VHF 300 Series Radio Installation Instructions
North American Models
VHF 300
VHF 300 AIS
GHS
and click
Contact Support
International Models
VHF 300i
VHF 300i AIS
10
GHS 10i
™
for in-country support information, or contact Garmin (Europe) Ltd. by
190-01098-02 Rev. C
dealer immediately.
®
Printed in China