Garmin VHF GHS 10 Інструкція з монтажу Посібник з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Морське радіо Garmin VHF GHS 10. Garmin VHF GHS 10 12 сторінок. Vhf 300 series
Також для Garmin VHF GHS 10: Інструкція з монтажу Посібник з монтажу (12 сторінок)
Друкувати сторінку
Installing your VHF 300 Series Radio
1. Select locations for the radio components.
2. Install the transceiver box
3. Install the active speaker
4. Install the GHS 10
(page
Selecting Locations for the VHF 300 Series Radio Components
Use the diagram to determine how to best organize the VHF 300 series radio components on your boat. Test to be sure the cables reach all
components before permanently mounting any component.
Antenna connector
GHS 10 station 1
This GHS 10 must
be located in the
wheelhouse or an
adjacent room per
FCC law.
(not included)
GHS 10
GHS 10 with a passive speaker
Notes:
•
Install the transceiver box in a dry, protected location.
(page
3).
(page
4).
5).
VHF 300 transceiver box
GHS 10 cable
extension
(optional)
GHS 10
cable
Passive
speaker
VHF 300 Series Layout Diagram
Although these options are not necessary to use your radio, these
instructions cover the following additional installation options.
•
Connecting the GHS 10 to a passive speaker
•
Connecting the radio to a chartplotter or another GPS device
(page
5)
•
Connecting the radio to a hailer horn
NMEA 000 drop
cable (optional)
VHF 300 power/data cable
Clip and tape
bare wires
Active
speaker
GHS 10 active
cable
speaker
Bulkhead pass-through
plate
GHS 10
GHS 10 with an active speaker
(page
5)
(page
7).
NMEA 000 network
(optional)
NMEA 0183
device
(optional)
Hailer horn
(optional)
10 A
fuse
Switch
1 Vdc
VHF 300 Series Installation Instructions