Garmin BarkLimiter Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Засіб для догляду за домашніми тваринами Garmin BarkLimiter. Garmin BarkLimiter 8 сторінок. Owner's manual
Також для Garmin BarkLimiter: Інформація про продукт (12 сторінок), Декларація про відповідність (6 сторінок), Посібник користувача (7 сторінок)
Друкувати сторінку
Introduction
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Device Overviews
BarkLimiter Device
Contact points
Mode and intensity dial
Status LED
BarkLimiter Deluxe Device
Contact points
Mode and intensity dial
Status LED
Charging clip contacts (BarkLimiter Deluxe model only)
Attaching the Dog Collar Device to the Collar
Strap
1
With the buckle
facing outward, insert the end of the collar
strap through the slot
2
Pull approximately two-thirds of the collar strap through the
slot.
3
Insert the end of the collar strap through the slot
opposite side of the device.
4
Pull the strap until it is tight across the front of the device.
Charging the BarkLimiter Deluxe Device
To prevent corrosion, thoroughly dry the contacts on the collar
and the surrounding area before connecting the charging clip.
Introduction
WARNING
on the collar device.
NOTICE
Before you put the collar on the dog, remove the charging clip. If
you do not remove the clip, it may become detached from the
collar and become lost.
You should fully charge the battery before you use the device
for the first time. Charging a fully depleted battery takes about
two hours. The device will not charge when outside the
temperature range of 32° to 104°F (0° to 40°C).
1
Snap the charging clip
2
Plug the small end of the power cable into the mini-USB port
on the charging clip.
3
Plug the other end of the power cable into a power source.
The status LED is solid red when the collar is charging.
4
After the status LED turns solid green, remove the charging
clip from the collar.
Turning On the Dog Collar Device
Rotate the dial away from N.
There is a 30-second delay before the device becomes active.
The status LED indicates the battery charge level for five
seconds and turns off. After an additional 25 seconds, the unit is
active. The status LED flashes occasionally to indicate that the
unit is detecting sound, motion, or vibration.
Turning Off the Dog Collar Device
Rotate the dial to N.
Rotating the Dial
Do not over-rotate the dial. The dial does not rotate past 7.
The dial is intentionally difficult to rotate. This helps to prevent
accidental rotation while the device is in use on the dog.
Insert a coin or similar object into the slot to rotate the dial.
When the device is active and properly fitted on the dog, it
detects and corrects barks automatically. You can adjust the
method and intensity of the corrections.
on the
The status LED flashes briefly when the device detects motion
or corrects a bark.
Short flash
Motion was detected, and no correction was applied.
Long flash
A bark was detected, and a correction was applied.
onto the device.
NOTICE
Bark Correction
1