AEG FAVORIT 50874 Посібник користувача - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник користувача для Посудомийна машина AEG FAVORIT 50874. AEG FAVORIT 50874 28 сторінок. Electrolux dishwasher favorit 50874
Друкувати сторінку
12
Multitab function
Use of rinse aid
Rinse aid makes it possible to dry the dishes without streaks and stains.
The rinse aid dispenser automatically adds rinse aid during the last rinsing phase.
Do these steps to fill the rinse aid dispenser:
1. Press the release button
2. Fill the rinse aid dispenser
3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during
the washing programme.
4. Close the rinse aid dispenser. Press the lid until it locks into position.
Adjust the rinse aid dosage
Factory set: position 3.
You can set the rinse aid dosage between position 1 (lowest dosage) and position 4 (highest
dosage).
Turn the rinse aid selector
Multitab function
The multitab function is for combi detergent tablets.
These tablets contain agents as detergent, rinse aid and dishwasher salt. Some types of
tablets can contain other agents.
Do a check if these tablets are applicable for the local water hardness. Refer to the in-
structions from the manufacturer.
When you set the multitab function, it stays on until you deactivate it.
The multitab function deactivates the flow of rinse aid and salt.
The multitab function deactivates the indicator lights of salt and rinse aid.
The programme duration can increase if you use the multitab function.
Activate the multitab function before the start of a washing programme.
You cannot activate the multitab function when the programme operates.
To activate the multitab function:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons D and E until the multitab indicator light comes on.
To deactivate the multitab function and use separately detergent, salt and rinse aid:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons D and E until the multitab indicator light goes off.
4. Fill the salt container and rinse aid dispenser.
5. Adjust the water hardness setting to the highest level.
6. Do a washing programme without dishes.
7. Adjust the water softener to the water hardness in your area.
8. Adjust the rinse aid dosage.
6
to open the lid
3
with rinse aid. The mark 'max' shows the maximum level.
4
to increase or decrease the dosage.
5
of the rinse aid dispenser.