AEG FAVORIT 625 i Інструкція з експлуатації Посібник з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Посудомийна машина AEG FAVORIT 625 i. AEG FAVORIT 625 i 16 сторінок. Dishwashers
Також для AEG FAVORIT 625 i: Інструкція з експлуатації Посібник з експлуатації (16 сторінок), Інструкція з експлуатації Посібник з експлуатації (16 сторінок)
Друкувати сторінку
Programmes — Switching on
Switching on
Programme chart — see next page.
1. Turn on the water supply.
2. Press ON/OFF button and programme button
(fig. 1/A) to start the programme.
Note: Keep selected programme button
depressed for at least 2 sec. until programme
starts.
Switching Off
The light signal next to the symbol *6~ on the
control panel (fig. 1/C) indicates when the last
water intake has been completed. At this point
you can turn off the water tap.
The dishwasher switches itself off automati-
cally when the programme is finished. This is
indicated by a light next to the symbol }.
@
Release the ON/OFF button. The pilot light
goes out.
@ Then open the door (steam will escape from
the tub!) and leave it slightly ajar. Wait
approx. 15 minutes before unloading the
machine. If the dishwasher is built under and
the underside of your work surface is not pro-
tected against moisture or if it has a solid
wood edge, leave the dishwasher door
closed and unload when the crockery is com-
pletely dry.
Programme Sequence Indicator
Figure 1D
Light signals next to the individual symbols indi-
cate the programme sequence. The symbols are
as follows:
Mm
wash with detergent
i\\_ pre-rinse or intermediate rinse
final rinse with rinse aid
hot air drying
b|
Programme end
The indicator stops during the wash and the final
rinse until the water has reached the required
temperature.
@
Empty the lower basket first and then the top
basket. This prevents any water which may
have collected in recessed or curved items in
the top basket from dripping onto crockery in
the lower basket.
@ Check the filters after every programme. If
they are dirty clean them as per instructions
on page 12.
Programme Correction
If you have selected the wrong programme by
mistake press programme buttons
Ay and
S 65° simultaneously. The programme moves
quickly through the various stages to the re-start
position and you can select a new programme.
10