LG 230/208V Посібник з експлуатації - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Мобільний телефон LG 230/208V. LG 230/208V 35 сторінок. Lg service manual room air conditioner

Друкувати сторінку

1. PREFACE

1.1 SPECIFICATIONS ..........................................3

1.2 FEATURES AND BENEFITS ..........................4

1.3 CONTROL LOCATIONS .................................6

1.4 ADDITIONAL CONTROLS..............................7

2. DISASSEMBLY INSTRUCTIONS

2.1 MECHANICAL PARTS....................................9

2.1.1 FRONT GRILLE .....................................9

2.1.2 CONTROL BOX (Half-Disassembly)....10

2.1.3 CONTROL BOX (Full-Disassembly) ....10

2.2 AIR HANDLING PARTS................................11

2.2.1 HEATER ASSEMBLY AND CROSS

FLOW FAN...........................................11

2.2.2 FAN ......................................................11

2.2.3 SHROUD..............................................12

2.3 ELECTRICAL PARTS ...................................12

2.3.1 OUTDOOR MOTOR ............................12

2.3.2 INDOOR MOTOR ................................12

2.3.3 COMPRESSOR ...................................12

2.3.4 CAPACITOR ........................................12

2.3.5 POWER CORD ....................................13

2.3.6 P.C.B....................................................13

2.4 REFRIGERATION CYCLE............................14

1. PREFACE

SERVICE MANUAL

This

parts etc. This room air conditioner was manufactured and assembled under a strict quality control system.

The refrigerant is charged at the factory. Be sure to read the safety precautions prior to servicing the unit.

1.1 SAFETY PRECAUTIONS

1. When servicing the unit, set the ROTARY SWITCH

or POWER SWITCH to OFF(O) and unplug the

power cord.

2. Observe the original lead dress.

If a short circuit is found, replace all parts which

have been overheated or damaged by the short

circuit.

3. After servicing the unit, make an insulation

resistance test to protect the customer from being

exposed to shock hazards.

CONTENTS

provides various service information, including the mechanical and electrical

-2-

2.4.1 CONDENSER ......................................14

2.4.2 EVAPORATOR ....................................14

2.4.3 CAPILLARY TUBE...............................14

3. INSTALLATION

3.1 HOW TO INSTALL THE UNIT ......................17

3.2.1 PREPARATION OF SLEEVE ..............18

3.2.2 PREPARATION OF THE FRONT

GRILLE ................................................18

3.2.3 UNIT INSTALLATION ..........................19

3.3 ELECTRICAL REQUIREMENTS ..................20

3.3.1 ELECTRICAL DATA (FOR 230V/208 MODEL)........20

3.3.2 ELECTRICAL SAFETY ............................20

4. FERFORMANCE DATA

5. TROUBLESHOOTING GUIDE

5.1 OUTSIDE DIMENSIONS...............................26

5.2 PIPING SYSTEM ..........................................26

5.3 TROUBLESHOOTING GUIDE......................27

6. SCHEMATIC DIAGRAM

7. EXPLODED VIEW

8. REPLACEMENT PARTS LIST

1.2 INSULATION RESISTANCE TEST

1. Unplug the power cord and connect a jumper

between 2 pins (black and white).

2. The grounding conductor (green or green & yellow)

is to be open.

3. Measure the resistance value with an ohm meter

between the jumpered lead and each exposed

metallic part on the equipment at all the positions

(except OFF or O) of the ROTARY SWITCH.

4. The value should be over 2M .

.................................21

.....................32

..................................33

.......34