Fujitsu ABY36TL MA Посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Кондиціонер Fujitsu ABY36TL MA. Fujitsu ABY36TL MA 27 сторінок.
Друкувати сторінку
OPERATION
Instructions relating to heating(*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
Instructions relating to "the indoor unit's indicator lamp" (**) are applicable to "CEILING SUSPENSION TYPE" and "FLOOR
CONSOLE/UNDER CEILING DUAL TYPE".
To Select Mode Operation
1
Press the START/STOP button.
The unit will start and the remote controller's operation lamp (green) and
**the indoor unit's OPERATION indicator lamp (red) will light up.
2
Press the MASTER CONTROL button to select the de-
sired mode.
AUTO
COOL
To Set the Thermostat
Press the SET TEMP./DAY button to the desired temperature.
▲ : Press to raise the thermostat setting.
▼ : Press to lower the thermostat setting.
●
Thermostat setting range:
AUTO .................................. 18 to 30 °C
* Heating ............................... 16 to 30 °C
Cooling ............................... 18 to 30 °C
The thermostat cannot be used to set room temperature during the FAN mode
(the temperature will not appear on the remote controller's display).
The thermostat setting should be considered a standard value, and may
differ somewhat from the actual room temperature.
To Set the Fan Speed
Press the FAN CONTROL button to select the fan speed.
AUTO
When set to AUTO:
* Heating : Fan operates so as to optimally circulate warmed air.
However, the fan will operate at very low speed when the tem-
perature of the air issued from the indoor unit is low.
Cooling : As the room temperature approaches that of the thermostat set-
ting, the fan speed becomes slower.
Fan
: The fan alternately turns on and off; when on, the fan runs at the
low fan speed.
The fan will operate at a very low setting during Monitor opera-
tion.
To Stop Operation
Press the START/STOP button.
**The OPERATION indicator lamp (red) will go out.
The remote controller's operation lamp (green) will go out.
The display contents disappear and only the current time is displayed.
*HEAT
FAN
HIGH
MED
LOW
CLOCK
TEMP
NON STOP
AUTO
°C
HIGH
1
2
TIMER
SET TIME
TEMP./DAY
FAN
MODE
CONTROL
CLOCK ADJUST
SET
DAY OFF
Example: When set to AUTO.
CLOCK
TEMP
NON STOP
AUTO
°C
HIGH
1
2
TIMER
SET TIME
TEMP./DAY
FAN
MODE
CONTROL
CLOCK ADJUST
SET
DAY OFF
Example: When set to 26 °C.
NON STOP
CLOCK
TEMP
AUTO
°C
HIGH
1
2
TIMER
SET TIME
TEMP./DAY
FAN
MODE
CONTROL
CLOCK ADJUST
SET
DAY OFF
Example: When set to HIGH.
AUTO
DEFROST TEST
MASTER
CONTROL
2
START/STOP
1
AUTO
DEFROST TEST
MASTER
CONTROL
START/STOP
AUTO
DEFROST TEST
MASTER
CONTROL
START/STOP
En-7