AEG OKO_FAVORIT 64800 Інструкція з експлуатації Посібник з експлуатації - Сторінка 33
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Посудомийна машина AEG OKO_FAVORIT 64800. AEG OKO_FAVORIT 64800 48 сторінок. Aeg dishwasher öko favorit 64800
Також для AEG OKO_FAVORIT 64800: Інструкція з експлуатації Посібник з експлуатації (42 сторінок)
Друкувати сторінкуWhat to do, if...
Try to rectify minor faults on the dishwasher with the aid of the instructions
given here.
...a flashing fault code appears
an audible signal informs you that an alarm has been activated, in the
display appears one of the following flashing alarms: AL1 - AL2 - AL3 - AL4 -
AL5 - AL6 - AL7 and the indicator light of the phase under way is flashing.
They are indicative of a fault in the dishwasher that you can probably rectify
yourself.
- Press the ON/OFF push button to switch the dishwasher off.
- Open the door and carry out the following suggested corrective actions.
Fault code
"DOOR" indicator light
flashes
"WATER" indicator light
flashes and/or alarm AL5
Alarm AL6
Alarm AL4
Alarms AL1 - AL2 - AL3 -
AL7 - AL8
Once you have checked the possible causes listed above, switch on the
dishwasher and start a wash programme, if the fault code reappears contact
the Service Force Centre.
Possible cause
The door has not been
properly closed.
The water tap is closed.
The mains water supply has
been cut off.
The inlet hose may be
squashed or bent.
The inlet hose may be
blocked.
The drain hose may be
squashed or bent. The drain
hose extension is not
correct.
The sink may be blocked.
Protection against flooding
is active.
General
Remedy
Close the door.
Open the water tap.
Wait for the supply to be
restored.
Reposition correctly the
hose.
Switch off the water
supply and clean the filter.
Reposition correctly the
drain hose. Follow the
instructions for
connecting to the waste.
Clear any blockages.
Close the water tap and
contact the Service Force
Centre.
Switch off the dishwasher,
switch back on and start a
wash programme. If the
fault code reappears
contact the Service Force
Centre.
33