AEG 61100MF-an Інструкція з експлуатації та інструкція з монтажу - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція з експлуатації та інструкція з монтажу для Варильна поверхня AEG 61100MF-an. AEG 61100MF-an 24 сторінки. Glass ceramic cooking surface
Також для AEG 61100MF-an: Посібник з експлуатації та встановлення (24 сторінок), Інструкція з експлуатації та монтажу (24 сторінок)

All manuals and user guides at all-guides.com

Installation Instructions

Safety Instructions for the Installer

A device must be included in the electrical installation that makes it possi

ble to isolate the appliance from the mains supply with a minimum contact

separation of 3 mm.

Suitable isolation devices are e.g. cut-outs, fuses (remove screw type fuses

from the holder), earth leakage trips and circuit breakers.

In respect of fire protection, this appliance corresponds to type Y (IEC

335-2-6). Only this type of appliance may be installed with a high cupbo

ard or wall on one side.

It is not permitted to fit drawers below the cooking surface.

Protection against electric shock must be provided by the installation.

The kitchen unit in which the appliance is fitted must satisfy the require

ments of DIN 68930 in respect of stability.

Built-in ovens and cooking surfaces are fitted with special connector sy

stems. They may only be combined with appliances with a matching system.

All cut surfaces are to be sealed with a suitable sealant for protection

against moisture.

On tiled work surfaces, the joints in the area where the hob sits on the sur

face must be completely filled with grout.

On natural, artificial stone, or ceramic tops, the snap action springs must be

bonded in place.

Ensure that the seal is correctly seated in the frame and that it is seated

against the work surface without leaving any gaps. Additional silicon sea

lant must not be applied, this will make removal more difficult in the event

of the need for service.