AEG 75552G Інструкція з експлуатації Посібник з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Варильна поверхня AEG 75552G. AEG 75552G 24 сторінки. Gas hob

Друкувати сторінку

Operation

Hob burners control knobs

The symbols on the knobs mean that :

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a pan

on the pan support.

To light a burner:

turn the relevant knob anticlockwise to maximum position

(

Upon ignition, keep the knob pushed down about 5

seconds. This will allow the "thermocouple" (Fig. 1 -

letter D) to be heated and the safety device to be switched

off, otherwise the gas supply would be interrupted.

Then adjust the flame as required.

If the burner does not ignite, turn the control knob to zero, and try again.

When switching on the mains, after installation or a power cut, it is quite normal for the spark

generator to be activated automatically.

In the absence of electricity, ignition can occur without the electrical device; in this case,

approach the burner with a flame, push the relevant knob down and turn it anti-clockwise

until it reaches the "maximum" position.

To ensure maximum burner efficiency, you should only use pots and pans with a flat

bottom fitting the size of the burner used (see table).

As soon as a liquid starts boiling, turn down the flame so that it will barely keep the

liquid simmering.

If you use a saucepan which is smaller than the recommended size, the flame will

spread beyond the bottom of the vessel, causing the handle to overheat.

Take care when frying food in hot oil or fat, as the overheated splashes

could easily ignite.

If the control knobs become difficult to turn, please contact your local Service Force

Centre.

Burner

Triple-crown (ultra-rapid)

Large (rapid)

Medium (semi-rapid)

Small (auxiliary)

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

minimum

maximum

diameter

160 mm

260 mm

160 mm

240 mm

120 mm

220 mm

80 mm

160 mm

Fig. 1