AEG 99852 G Інструкція з експлуатації Посібник з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Варильна поверхня AEG 99852 G. AEG 99852 G 24 сторінки. Electrolux gas hob operating instructions 99852 g
Також для AEG 99852 G: Брошура та технічні характеристики (12 сторінок), Інструкція з експлуатації Посібник з експлуатації (24 сторінок)

Operation

Hob burners

To light a burner:

Push in the relevant control knob and turn it to maximum position.

Upon ignition, keep the knob pushed down about 5 seconds. This will allow the

"thermocouple" (fig. 1 - letter C) to be heated and the safety device to be switched off,

otherwise the gas supply would be interrupted.

Then adjust the flame as required.

If the burner does not ignite, turn the control knob to zero, and try again.

Each control knob is equipped with a pilot light which gradually lights up according to the

heat level that you select with the control knob.

When switching on the mains, after installation or a power cut, it is quite normal for the

spark generator to be activated automatically.

To ensure maximum burner efficiency, you should only use pots and pans with a flat

bottom fitting the size of the burner used (see table).

Burner

Large (ultra-rapid)

Medium (semi-rapid)

Small (Auxiliary)

As soon as a liquid starts boiling, turn down the flame so

that it will barely keep the liquid simmering.

If you use a saucepan which is smaller than the

recommended size, the flame will spread beyond the

bottom of the vessel, causing the handle to overheat.

Take care when frying food in hot oil or fat, as the

overheated splashes could easily ignite.

If the control knobs become difficult to turn, please

contact your local Service Force Centre.

minimum

maximum

diameter

180 mm.

260 mm.

120 mm.

220 mm.

80 mm.

160 mm.

A - Burner cap

B - Ignition electrode

C - Thermocouple

Fig. 1