Brother HL-1118 Інструкція з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Принтер Brother HL-1118. Brother HL-1118 7 сторінок.
Також для Brother HL-1118: Посібник з безпеки продукції (19 сторінок), Посібник з швидкого налаштування (2 сторінок), Посібник з безпеки продукції (19 сторінок)
WARNING: You must ensure all toner is
dumped from your cartridge before refilling with
the new toner. You must do this every refill.
Important - mixing new and old toner will cause
print defects to occur.
Shake your bottle of
new toner
vigorously for 30
seconds BEFORE
removing the cap.
Remove the cap and
seal from the bottle
STOP: Take your time when refilling.
An original cartridge contains 30g of toner. Our bottle contains 70g – that's more than double the amount of
toner than an original cartridge.
You can add the whole bottle - but it will barely fit in the cartridge. You will need to allow the toner to
settle inside the cartridge to get the toner in.
We advise adding half a bottle and topping it up later. Add 30-35g per fill (approx half a bottle)
(Each bottle contains 70g of toner – the bottle containing the toner but without the lid - will weigh approx
105g. So if you add 30g the bottle without the lid will then weigh approx 75g)
Insert the spout into
the hole. The toner
will flow out like
water, so take care
not to spill it.
Empty in an area
that can tolerate a
toner spill i.e. your
garage.
Toner can be very
messy - empty the
old toner directly
into a large bin bag.
Fit the toner pouring
spout securely to the
bottle.
Spouts are
reusable.
A
With the spout
inserted – carefully
"Upend" the
cartridge and allow
the toner to slowly
pour into the
cartridge.
Do not squeeze
the bottle.
© Zinetic.co.uk. All Rights Reserved
Please read instructions from start to finish
before you start your refill.
B