2N BlueTower Як встановити - Сторінка 3

Переглянути онлайн або завантажити pdf Як встановити для Шлюз 2N BlueTower. 2N BlueTower 5 сторінок.

default gateway. Then go to the"VoIP parameters" where you can set IP address of VoIP

card, it's called "VoIP card/MGCP gateway".

The last step now is to set IP address on eCPU. To do that you have to switch off your

gateway and plug out CPU board from the case (unscrew both screws). Disconnect

jumper number 2 (check following picture) and plug back the CPU board to case.

Switch on the gateway and connect back serial cable. Run whatever software which is

providing telnet connection (hyperterminal, PuTTy etc.). Again choose right COM port

number and for serial communication speed set 115200 bit/s. Start your connection and

press "ENTER" to see main menu. Go to the menu Configuration -> Network -> and set

IP address, Subnet mask and IP of default network gateway. Then switch off your

gateway again, plug out CPU board and connect back jumper number JP2. When you are