Fujitsu Wall Mounted Type Посібник з монтажу - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник з монтажу для Кондиціонер Fujitsu Wall Mounted Type. Fujitsu Wall Mounted Type 18 сторінок. Air conditioner outdoor unit, wall mounted type, r410a
Друкувати сторінку
Cooling Room Temperature Correction
• Depending on the installed environment, the room tempera-
ture sensor may require a correction.
The settings may be selected as shown in the table below.
Setting Description
♦
Standard
Slightly lower control
Lower control
Warmer control
Heating Room Temperature Correction
• Depending on the installed environment, the room tempera-
ture sensor may require a correction.
The settings may be changed as shown in the table below.
Setting Description
♦
Standard
Lower control
Slightly warmer control
Warmer control
Auto Restart
• Enable or disable automatic system restart after a power
outage.
Setting Description
♦
Yes
No
* Auto restart is an emergency function such as for
power failure etc. Do not start and stop the indoor unit
by this function in normal operation. Be sure to oper-
ate by the control unit, or external input device.
Indoor room temperature sensor switching function
(Only for wired remote controller)
• The following settings are needed when using the wired
remote controller temperature sensor.
Setting Description
♦
No
Yes
* If setting value is "00" :
Room temperature is controlled by the indoor unit tempera-
ture sensor.
* If setting value is "01" :
Room temperature is controlled by either indoor unit tem-
perature sensor or remote controller unit sensor.
(♦... Factory setting)
Function
Setting
Number
Value
00
01
30
02
03
(♦... Factory setting)
Function
Setting
Number
Value
00
01
31
02
03
(♦... Factory setting)
Function
Setting
Number
Value
00
40
01
(♦... Factory setting)
Function
Setting
Number
Value
00
42
01
Remote controller signal code
• Change the indoor unit Signal Code, depending on the
remote controllers.
Setting Description
♦
A
B
C
D
External input control
• "Operation/Stop" mode or "Forced stop" mode can be elected.
Setting Description
♦
Operation/Stop mode
(Setting forbidden)
Forced stop mode
Setting record
• Record any changes to the settings in the following table.
Setting Description
Filter sign
Cooler room temperature correction
Heater room temperature correction
Auto restart
Indoor room temperature sensor
switching function
Remote controller signal code
External input control
After completing the FUNCTION SETTING, be sure to turn off
the power and turn it on again.
(♦... Factory setting)
Function
Setting
Number
Value
00
01
44
02
03
(♦... Factory setting)
Function
Setting
Number
Value
00
46
01
02
Setting Value
En-15