AEG Automatic Refrigerator Інструкція з експлуатації Посібник з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Пральна машина AEG Automatic Refrigerator. AEG Automatic Refrigerator 10 сторінок. Aeg automatic washing machines
Також для AEG Automatic Refrigerator: Інструкція з експлуатації Посібник з експлуатації (11 сторінок), Інструкція з монтажу та підключення (14 сторінок)

Друкувати сторінку

AEG Automatic Refrigerator Інструкція з експлуатації Посібник з експлуатації

Special accessories:

A = Ventilation grille, brown (E-No. 621 814 002)

B = Ventilation grille, white (E-No. 621 825 004)

Detaching the worktop

Fig. 2

After removal of the worktop of your refrigerator, the

appliance can be installed under a continuous

worktop. To do this, proceed as follows:

Unscrew the Phillips screws (A).

Unscrew the front screws (C).

Mounting under a continuous

worktop

Fig. 3

If installed under a continuous worktop, the appli-

ance is fastened with a mounting screw (A) under

the panel.

Rehingeing the door

Figs. 4, 5, 6

Before you connect the appliance to the power

supply you should check whether the door should

close to the right (as delivered) or should better be

changed over to the left if the position and ease of

use require. If so:

1. Tilt the appliance slightly towards the rear and

prop it securely.

2. Unscrew the door hinge screws (K) and take the

door bearing (1) downwards out of its cavity

(Fig. 4).

3. Open the door a little way and take it out down-

wards.

4. Unscrew the upper pin (A) (Fig. 5) and screw it

into place on the opposite side.

5. Fit the door into the upper pin (A) and close it.

6. Insert the pin of the door bearing (1) into the left

hand cavity and screw the bearing ﬁrmly into

place with the screws (K).

7. Unscrew the door handle and screw it in place on

the opposite d side of the door. Use the plastic

caps to cover the unused screw holes (Fig. 6).

Cleaning before using for the

ﬁrst time

Like all new appliances, your refrigerator will smell

"new". For this reason, the interior of the refrigerator

and all accessories should be cleaned before use

(see also "Cleaning and care").

Electrical connection

WARNING - THIS APPLIANCE MUST BE

EARTHED

Please ensure that the voltage and current indicated

on the rating plate agrees with the voltage of your

electricity supply.

220/240 volts ~ (i. e. 220/240 V AC).

If your appliance has been equipped with a mains

lead with a moulded-on type plug, you must comply

with the following regulations: The plug moulded on

to the cord incorporates a fuse. For replacement,

use a 13 amp BS 1362 fuse. Only ASTA approved

or certiﬁed fuses should be used. The fuse cover/

carrier must be replaced in the event of changing

the fuse. The plug must not be used if the fuse

cover/ carrier is lost. A replacement cover/carrier

must be obtained from an electrical goods retailer. If

the socket outlets in your home are not suitable for

the plug ﬁtted to the appliance, then the plug must

be cut off and an appropriate one ﬁtted. When

ﬁtting the plug please note the following points:

Important

The wires in the mains lead are coloured in accord-

ance with the following code:

Green and Yellow

Blue

Brown

As the colours of the wires in the mains lead of this

appliance may not correspond with the coloured

markings identifying the terminals in your plug,

proceed as follows:

1. The wire which is coloured GREEN and YEL-

LOW must be connected to the EARTH termi-

nal in your plug, which is marked with the letter

E or by the earth symbol

GREEN, or GREEN and YELLOW.

2. The wire which is coloured BROWN must be

connected to the LIVE terminal which is marked

with the letter L or coloured RED.

3. The wire which is coloured BLUE must be con-

nected to the neutral terminal which is marked

with the letter N or coloured BLACK.

Earth

Neutral

Live

or coloured