AEG EWF 1245 Інструкція з експлуатації - Сторінка 23

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Пральна машина AEG EWF 1245. AEG EWF 1245 26 сторінок.

Друкувати сторінку

• Remove any objects from the pump impeller by

rotating it.

• Put the cap back on the emergency emptying

hose and place the latter back in its seat.

P1117

• Screw the pump fully in.

• Close the pump door.

Water inlet filter

If you notice that the machine is taking longer to fill,

check that the filter in the water inlet hose is not

blocked.

Turn off the water tap.

Unscrew the hose from the tap.

Clean the filter with a stiff brush.

Screw the hose back onto the tap.

P1090

All manuals and user guides at all-guides.com

Emergency emptying out

If the water is not discharged, proceed as follows to

empty out the machine:

• pull out the plug from the power socket;

• close the water tap;

• if necessary, wait until the water has cooled down;

• open the the pump door;

• place a bowl on the floor and place the end of the

emergency emptying hose into the bowl. Remove

its cap. The water should drain by gravity into the

bowl. Whe the bowl is full, put the cap back on the

hose. Empty the bowl. Repeat the procedure until

water stops flowing out;

• clean the pump if necessary as previously

described;

• replace the emergency emptying hose in its seat

after having plugged it;

• screw the pump again and close the door.

Frost precautions

If the machine is installed in a place where the

temperature could drop below 0°C, proceed as

follows:

• Remove the plug from the socket.

• Close the water tap and unscrew the water inlet

hose from the tap.

• Place the end of the emergency emptying hose

and that of the inlet hose in a bowl placed on the

floor and let water drain out.

• Screw the water inlet hose back on and reposition

the emergency emptying hose after having put the

cap on again.

By doing this, any water remaining in the machine is

removed, avoiding the formation of ice and,

consequently, breakage of the affected parts.

When you use the machine again, make sure that

the ambient temperature is above 0°C.