Fujitsu LifeBook C-6651 Посібник з біосу - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з біосу для Ноутбук Fujitsu LifeBook C-6651. Fujitsu LifeBook C-6651 37 сторінок. Bios setup utility
Також для Fujitsu LifeBook C-6651: Посібник з програмного забезпечення (39 сторінок)
Друкувати сторінку
L i f e B o o k C S e r i e s B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA
devices are installed.
Main
Primary Master [TOSHIBA MK3018GAP -(PM)]
Type:
Maximum Capacity:
Multi-Sector Transfers:
LBA Mode Control:
PIO Transfer Mode:
DMA Transfer Mode:
F1
Help
ESC
Exit
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field
Options
Type:
Auto
n
None
n
CD-ROM
n
Hard Disk
n
Cylinders:
A number
n
between
0 and 65,535
Heads:
A number
n
between
1 and 16
Sectors:
A number
n
between
0 and 63
6
PhoenixBIOS Setup Utility
[Auto]
30006MB
[16 Sectors]
[Enabled]
[Fast PIO 4]
[Ultra DMA 5]
Select Item
-/Space
Select Menu
Enter
Figure 2. Primary Master Submenu
Default
Description
[Auto]
Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected, all of the
following Set-up items do not appear. Select CD-ROM if a CD-ROM drive
is installed at this connection. If Hard Disk is selected, you must specify the
number of Cylinders, Heads, and Sectors for the drive.
–—
This appears only when Hard Disk is selected. When Hard Disk is selected,
you can change the value. This field is incremented by pressing the
[Spacebar]) or by pressing [Shift] [+]. This field is decremented by pressing
the [-] key. You can also change the field by typing in the number.
–—
This appears only when Hard Disk is selected. When Hard Disk is selected,
you can change the value. This field is incremented by pressing the
[Spacebar]) or by pressing [Shift] [+]. This field is decremented by pressing
the [-] key. The field can also be changed by typing in the number.
–—
This appears only when Hard Disk is selected. When Hard Disk is selected,
you can change the value. This field is incremented by pressing the
[Spacebar]) or by pressing [Shift] [+]. This field is decremented by pressing
the [-] key. The field can also be changed by typing in the number.
*Note that actual hard drive label shown may vary.
Depending on the drive type, information such as cylin-
ders, heads and sectors may also be displayed.
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Change Values
F9
Select
Sub-Menu
F10
Setup Defaults
Save and Exit