Brother P-TOUCH CUBE Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Виробник етикеток Brother P-TOUCH CUBE. Brother P-TOUCH CUBE 18 сторінок. Tze tape
Також для Brother P-TOUCH CUBE: Посібник користувача (18 сторінок), Посібник користувача (25 сторінок), Посібник користувача (18 сторінок), Посібник користувача (18 сторінок)

Federal Communications Commission (FCC) Declaration of Conformity

Responsible Party: Brother International Corporation

Product Name :

Model Number :

Label printer complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) Label printer may not cause harmful interference, and (2) label printer

must accept any interference received, including interference that may cause undesired

operation.

Label printer has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. Label printer generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If label printer

does cause harmful interference to radio or television reception, which can be determined

by turning the label printer off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the label printer and receiver.

• Connect the label printer into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

• This transmitter must not be co-located or operated in conjunction with any other antenna

or transmitter.

Important

• The enclosed interface cable should be used in order to ensure compliance with the limits

for a Class B digital device.

• Changes or modifications not expressly approved by Brother Industries, Ltd. could void the

user's authority to operate the label printer.

CAUTION: To maintain compliance with FCC's RF exposure guidelines, use only the

supplied antenna. Unauthorize antenna, modification, or attachments could damage the

transmitter and may violate FCC regulations.

This label printer complies with FCC/IC radiation exposure limits set forth for an uncontrolled

environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the

IC radio frequency (RF) Exposure rules. This label printer has very low levels of RF energy that

are deemed to comply without testing of specific absorption rate (SAR).

(For USA Only)

200 Crossing Boulevard

Bridgewater, NJ 08807-0911, U.S.A.

TEL : (908) 704-1700

Brother Label Printer Electronic Labeling System

PT-P300BT