AEG L 61470 BI Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Пральна машина AEG L 61470 BI. AEG L 61470 BI 36 сторінок. Washing machines
Також для AEG L 61470 BI: Посібник користувача (36 сторінок)
Друкувати сторінку
16
www.aeg.com
10.6 Altering an option or a
running programme
It is possible to change some options
before the programme operate. Before
you make any change, you must press
the Start/Pause button to pause the
appliance.
Changing a running programme is
possible only by resetting it.
Turn the programme dial to Off and then
to the new programme position.
Press the Start/Pause button again to
start the new programme. The washing
water in the tub will not be drained.
10.7 Interrupting a
programme
Press the Start/Pause button to interrupt
a programme which is running, the
corresponding indicator starts flashing.
Press the Start/Pause button again to
restart the programme.
10.8 Cancelling a running
programme
Turn the programme dial to Off to cancel
a programme which is running. Now you
can select a new programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.9 Opening the door
While a programme or the delay start
operates, the appliance door is locked.
If you need to open the door, press the
Start/Pause button to pause the
appliance.
If the Extra Rinse indicator after a few
minutes goes off, the door can be
opened.
WARNING!
If you cannot open the door but you
need to open it, turn the programme dial
to Off to switch the appliance off. After a
few minutes the door can be opened
(pay attention to the water level and
temperature !) .
After closing the door, it is necessary to
set the programme and the options
again. Press the Start/Pause button to
start the programme again.
10.10 At the end of the
programme
The appliance stops automatically. The
indicator of the Start/Pause button and
the Washing phase indicator go off. A
flashing
will appear on the display.
If you have set a programme or an
option that ends with water in the tub,
the Door indicator remains on. The door
is locked. The water must be emptied
out before opening the door.
During this time the drum continues to
turn at regular intervals until water drain.
Follow the below instructions to empty
the water out:
• Turn the programme dial to Off.
• Set the Drain or Spin programme.
• If necessary, reduce the spin speed.
• Press the Start/Pause button.
• When the programme is completed,
the display shows a flashing
Door indicator goes off. The door can
be opened.
Turn the programme dial to Off to switch
the appliance off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap.
Keep the door ajar to prevent mildew
and unpleasant smells.
10.11 Stand by
Once the programme has finished, after
a few minutes the energy saving system
will activate. The display will dim. Press
any button to deactivate the Stand By
function.
. The