Fujitsu Lifebook LH530 Інструкція з експлуатації - Сторінка 33
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Ноутбук Fujitsu Lifebook LH530. Fujitsu Lifebook LH530 34 сторінки. Lifebook ah530 notebook
Також для Fujitsu Lifebook LH530: Технічний паспорт (2 сторінок), Посібник з біосу (16 сторінок), Початок роботи (13 сторінок)
Друкувати сторінку
Problem
Video Problems
The built-in
The notebook is set for an
display is blank
external monitor only.
when you turn
on your LifeBook
notebook.
(continued)
The angle of the display
and the brightness
settings are not adequate
for your lighting conditions.
The power management
time-outs may be set for
very short intervals and
you failed to notice the
display come on and go
off again.
The LifeBook
Power On Self Test
notebook turned
(POST) has detected
on with a series of
a failure which does
beeps and your
not allow the display to
built-in display is
operate.
blank.
The display goes
The notebook has gone
blank by itself after
into Video Timeout,
you have been
Standby mode, Suspend
using it.
mode or Save-to-Disk
mode because you have
not used it for a period of
time.
The power management
time-outs may be set for
very short intervals and
you failed to notice the
display come on and go
off again.
Something is pushing on
the Closed Cover switch.
Possible Cause
T r o u b l e s h o o t i n g
Possible solution
Pressing [F10] while holding down the [Fn]
key allows you to change your selection of
where to send your display video. Each time
you press the combination of keys you will
step to the next choice. The choices, in order
are: built-in display only, external monitor only,
both built-in display and external monitor.
Move the display and the brightness control
until you have adequate visibility.
Press any button the keyboard, or move the
mouse to restore operation. If that fails, push
the Power/Suspend/Resume button. (The
display may be shut off by Stanby mode, Auto
Suspend or Video Timeout)
Contact your support representative.
Press any button on the keyboard, or move
the mouse to restore operation. If that fails,
push the Power/Suspend/Resume button.
Check your power management settings, or
close your applications and go to the Power
Savings menu of the setup utility to adjust the
timeout values to better suit your operation
needs.
Press any button on the keyboard, or move
the mouse to restore operation. If that fails,
push the Power/Suspend/Resume button.
(The display may be shut off by Standby
Mode, Auto Suspend or Video Timeout)
Check the Closed Cover switch.
25