Brother P-touch PT-D410 Посібник із швидкого старту - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Виробник етикеток Brother P-touch PT-D410. Brother P-touch PT-D410 9 сторінок.
Також для Brother P-touch PT-D410: Посібник (8 сторінок)
Друкувати сторінку
Problem
Solution
Printed barcodes or QR
• Change the tape. (Recommended: Black on white tape)
codes cannot be read.
• Enlarge the barcodes or QR codes using the barcode application,
if possible.
I do not know the firmware
Confirm the firmware version by pressing the following keys:
version of the Label
Maker.
When the label is printed,
• Refer to the Set Margins section in this guide and select [Small
there is too much margin
Margin] [Chain] or [No Cut] for smaller margins.
(space) on both sides of
When you set [Small Margin], the label maker feeds approx. 0.9"
the text.
(23 mm) of leader tape before every new label.
To save tape, set the [Chain] setting. After the last label prints,
press
Cutter Lever.
• The Label Maker feeds approx. 0.9'' (23 mm) of tape before every
new label. When printing multiple labels, you can reduce the blank
space on the second and subsequent labels.
Select the [Chain] setting in the optional print settings. Then, print
your labels and leave the last label in the Label Maker until you are
ready to print a new label.
• After the last label prints, press
feed the tape, and then eject and cut the last label. Note that the
Label Maker will feed approx. 0.9'' (23 mm) of tape before the next
new label when you use this method.
The font size cannot be
The font is already the maximum size for the width of the label. Or,
increased.
the label length has been set, so there is a limit on the font size to
prevent exceeding the set length.
When multiple labels are
When Chain Print is enabled, feed the tape to eject the last printed
printed, the last label is cut
label, and then press the Tape Cutter Lever to cut the label manually.
incorrectly.
[Version Information]
/
and
to feed the tape, and then press the Tape
and
simultaneously to
Troubleshooting (cont.)
Problem
Solution
I cannot update the printer's
Restart the printer and then try to update the firmware again. Do not
firmware using the P-touch
press any buttons during the firmware update.
Update Software, Transfer
Express, or Mac Update
Tool.
Contact Information
Customer Service for USA
Other countries or regions
DON'T FORGET TO REGISTER!
Registering your product will provide purchase confirmation, proof of ownership and, if
you choose, allow us to notify you of product enhancements and special offers!
You can register online at: www.registermybrother.com (USA)
LIMITED WARRANTY
Product warranty information can be found online at:
www.brother-usa.com/brother-support (USA)
Phone: 1-877-BROTHER (1-877-276-8437)
Fax: 1-901-379-1210
To order supplies and accessories:
www.brother-usa.com
Phone: 1-877-552-6255
support.brother.com