Brother P-touch PT-E110 Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Виробник етикеток Brother P-touch PT-E110. Brother P-touch PT-E110 18 сторінок. Electronic labeling system
Також для Brother P-touch PT-E110: Посібник користувача (18 сторінок), Посібник користувача (18 сторінок)
Друкувати сторінку
Troubleshooting
Error messages
Message
The batteries are weak.
Battery
If using AAA alkaline batteries,
Low!
replace them with new ones (do not
use a combination of old and new
batteries).
If using Ni-MH batteries, charge
them fully.
The installed batteries are
Battery
exhausted and need to be replaced
Empty!
for continued operation.
Invalid! • An invalid number was entered as
the label length, tab length, cable
diameter, flag length or faceplate
length.
• An invalid letter or number to be
incremented was selected in the
Serialize function.
• You tried to print a text file when
No Text!
there is no data stored in the
memory.
•
entered.
•
text is entered.
•
entered.
•
text was entered while using
templates.
• You tried to enter a 3rd line by
2 Line
Limit! /
pressing
1 Line
Limit!
• You tried to print or preview two
lines of text while 0.13" (3.5mm) or
0.23" (6mm) tape is installed. Install
a larger tape size.
There is no cassette installed.
No
1.888.610.7664
Install a cassette with the
Cassette!
Cause / Remedy
is pressed when no text is
+
is pressed when no
is pressed when no text is
or
was pressed when no
.
www.calcert.com
15
10
20
5
25
0
30
Message
Cutter
Pressed
Text
Full!
Text
Limit!
Change
Length
Feed OK? • Feeding tape after printing when
Wrong
Tape!
Use TZe
tape
mark
Cause / Remedy
The Tape Cutter Lever was pressed
in the middle of the printing process.
The maximum number of characters
(80 characters for text) have already
been entered.
You may have exceeded the set
tape length. Reduce the text or
select [Auto] as the tape length.
[Chain Print] is selected. Refer
to the Setting Margins section in
this guide.
• Use a cassette with the
mark.
mark or