AEG L6FBG942R Посібник користувача - Сторінка 32

Переглянути онлайн або завантажити pdf Посібник користувача для Пральна машина AEG L6FBG942R. AEG L6FBG942R 40 сторінок.
Також для AEG L6FBG942R: Посібник користувача (44 сторінок)

Друкувати сторінку

www.aeg.com

The programme was not finished

properly or the appliance stopped

too early. If the alarm code appears

again, contact the Authorised Service

Centre.

14.2 Possible failures

Problem

The programme does

not start.

The appliance does not

fill with water properly.

The appliance fills with

water and drains immedi-

ately

The appliance does not

drain the water.

The spin phase does not

operate or the washing

cycle lasts longer than

usual.

Possible solution

• Make sure that the mains plug is connected to the mains

socket.

• Make sure that the appliance door is closed.

• Make sure that there is no damaged fuse in the fuse box.

• Make sure that the Start/Pause has been touched.

• If the delay start is set, cancel the setting or wait for the end

of countdown.

• Deactivate the Child Lock function if it is on.

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not too

low. For this information, contact your local water authority.

• Make sure that the water tap is not clogged.

• Make sure that the inlet hose has no kinks, damages or

bends.

• Make sure that the connection of the water inlet hose is

correct.

• Make sure that the drain hose is in the correct position. The

hose may be positioned too low. Refer to "Installation in-

struction".

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

• Make sure that the drain filter is not clogged. Clean the fil-

ter, if necessary. Refer to "Care and cleaning".

• Make sure that the connection of the drain hose is correct.

• Set the drain programme if you set a programme without

drain phase.

• Set the drain programme if you set an option which ends

with water in the tub.

• Set the spin programme.

• Make sure that the drain filter is not clogged. Clean the fil-

ter, if necessary. Refer to "Care and cleaning".

• Adjust manually the items in the tub and start the spin

phase again. This problem may be caused by balance prob-

lems.

WARNING!

Deactivate the appliance

before carrying out any

check.