Brother DCP-8065DN Посібник з налаштування - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з налаштування для Факсимільний апарат Brother DCP-8065DN. Brother DCP-8065DN 23 сторінки. Scan to ftp (file transfer protocol)
Також для Brother DCP-8065DN: Посібник з швидкого налаштування (37 сторінок), Посібник (7 сторінок)
Друкувати сторінку
STEP 2
Installing the Driver & Software
How to connect the machine to your computer
For DCP-130C, MFC-240C, MFC-440CN,
MFC-5460CN and MFC-5860CN users
(The illustrations are based on MFC-5460CN.)
1
Lift the scanner cover until it locks securely into
the open position.
2
Connect the USB cable to the USB socket
marked with a
USB socket inside the machine on the right as
shown below.
3
Carefully guide the USB cable into the trench
as shown below, following the trench around
and toward the back of the machine. Then,
connect the cable to your computer.
6
symbol. You will find the
Improper Setup
• DO NOT connect the machine to a USB port on
a keyboard or a non-powered USB hub.
Brother recommends that you connect the
machine directly to your computer.
• Make sure that the cable does not restrict the
cover from closing, or an error may occur.
• Make sure you use a USB 2.0 cable that is no
longer than 6 feet long (2 meters).
4
Lift the scanner cover to release the lock ( ).
Gently push the scanner cover support
down ( ) and close the scanner cover ( ).
5
Turn on the machine by connecting the power
cord.
The installation of the Brother drivers will
automatically start. The installation screens
appear one after another. Please wait, it will
take a few seconds for all the screens to
appear.
Improper Setup
DO NOT try to cancel any of the screens during
this installation.
®
Windows