Fujitsu PRIMERGY BX900 S1 Посібник із сервісного доповнення - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник із сервісного доповнення для Сервер Fujitsu PRIMERGY BX900 S1. Fujitsu PRIMERGY BX900 S1 46 сторінок.
Друкувати сторінкуSafety notes
V
CAUTION!
For safety reasons, no more than one unit should be pulled out of the
rack at a time.
Make sure that the anti-tilt plate is correctly mounted when you set up
the rack.
The rack may tip over if more than one unit is removed at the same
time.
Before connecting or disconnecting cables, read the notes in the
chapter "Important Notes" in the technical manual for the relevant
rack. The technical manual for the rack is supplied with the rack.
The rack must be connected to the mains by an authorized specialist
(electrician).
If the server system is integrated in a rack installation that receives
power from an industrial (public) power supply network with the
IEC309 connector, the (public) power supply protection must comply
with the requirements for non-industrial (public) power supply
networks for the type A connector.
The power supply for the rack should be distributed over the three
phases of a three-phase mains connection.
Installation and operation
V
CAUTION!
If the rack model is integrated in an installation that receives power
from an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for the non-industrial (public) power supply networks for
the type A connector.
The server automatically sets itself to a voltage in the range of
100 V to 240 V. Make sure that your local voltage is within this range.
This device has a specially approved power cable and must only be
connected to a grounded insulated socket.
Ensure that the power socket on the device or the grounded wall
outlet is freely accessible.
12
Service Supplement
BX900 S1