Fujitsu Primergy RX200 S4 Посібник із сервісного доповнення - Сторінка 22
Переглянути онлайн або завантажити pdf Посібник із сервісного доповнення для Сервер Fujitsu Primergy RX200 S4. Fujitsu Primergy RX200 S4 39 сторінок.
Також для Fujitsu Primergy RX200 S4: Посібник з експлуатації (9 сторінок)
Друкувати сторінку
Replacing the chassis ID / temperature sensor
Ê Fasten the front panel module with the screw in the housing.
Ê Plug the front panel cable on the connector CN1 on the system board.
Ê Reinsert the air duct. Make sure that the hooks of the air duct engage in the
fan cage.
Ê Close the server and plug in the power plugs (detailed description see the
Options Guide).
4.3
Replacing the chassis ID / temperature
sensor
In this server, the chassis ID/temperature sensor is located on the front panel
board. Therefore, to replace the chassis ID/temperature sensor, you must
replace the front panel module (see
on page
20).
I
To enable ServerView and ServerStart to identify the system, the chassis
ID prom must be reprogrammed with the ChassisIDProm tool after the
new front panel module has been installed.
The tool can be downloaded from the Fujitsu Siemens Computers
Service and Support page (URL:
http://extranet.fujitsu-siemens.com/service/information/intelservers/tools).
4.4
Replacing the fan board
Ê Open the server as described in the
Ê Lift up the air duct and take it out as described in the
air duct" on page
Ê Remove all cables from the fan board.
Ê Remove all system fans from the fan cage (description see the Operating
Manual).
22
section "Replacing the front panel module"
19.
Service Supplement
Replacement routines
section "Preparation" on page
section "Removing the
17.
RX200 S4