Fujitsu PRIMERGY TX300 S3 Посібник із сервісного доповнення - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник із сервісного доповнення для Сервер Fujitsu PRIMERGY TX300 S3. Fujitsu PRIMERGY TX300 S3 47 сторінок.
Друкувати сторінку
Introduction
Information/procedure
Extensions and upgrades:
I
For some components only the installation
routine is described in the Options Guide.
Removing this components proceed in
reverse order.
– Extending/replacing the main memory
– Installing a second processor / replacing the
processor / replacing the heat sink
– Installing the ROMB upgrade kit
– Installing accessible drives
– Installing a Local View module
– Installing the SAS/SATA hard disk extension box
– Installing controller in the non-hot-plug PCI slots
– Installing a parallel interface for printers
– Converting from the floorstand model to the
rack model
Cabling
Replacement routines:
– Replacing the operating panel
– Replacing the processor fan holder
– Replacing the Power backplane
– Replacing the SAS/SATA backplane
– Replacing the intrusion switches
– Replacing the IDTEMP Combo
– Replacing the system board
Board layout
BIOS setup
Table 1: Overview of the documentation TX300 S3
TX300 S3
Overview of the documentation
Service Supplement
Manual
Options Guide
Service Supplement
BIOS Setup
7