Fujitsu SPARC Enterprise T5440 Server Посібник для початківців

Переглянути онлайн або завантажити pdf Посібник для початківців для Сервер Fujitsu SPARC Enterprise T5440 Server. Fujitsu SPARC Enterprise T5440 Server 8 сторінок.
Також для Fujitsu SPARC Enterprise T5440 Server: Оглядовий посібник (26 сторінок), Посібник з планування території (24 сторінок)

Друкувати сторінку

SPARC

Enterprise T5440 Server Getting Started Guide

This guide describes the minimum steps you must perform to get your server to power on and boot for the first time using the

preinstalled Solaris™ Operating System (Solaris OS).

SPARC Enterprise T5440 Server

FIGURE 1

Quick Setup Instructions

For quick installation and configuration, follow these steps. For more detailed information, refer to the complete online product

documentation set at:

http://www.fujitsu.com/sparcenterprise/manual/

Understand the following information before you set up the server for the first time:

Choose the best instructions for your situation – These quick setup instructions work for any networking environment, and

■

require the use of a terminal device for connectivity to a serial port. If you have a networking environment running DHCP, you

can configure your system using the Ethernet management port. To take advantage of the DHCP setup method, refer to the online

installation guide instead of these instructions.

Set aside sufficient time – Installation times vary, but if you are performing these setup instructions for the first time, plan to

■

spend about 45 to 75 minutes to complete all of these instructions. Additional time might be required for installing optional

hardware and rackmounting kits.

Gather your configuration information – During the configuration, you are prompted for time zone and networking parameters

■

that are specific to your environment. For a list of information you need, see

Obtain a terminal device – You configure this rackmountable server through the service processor (SP) using the built-in serial

■

and network management ports, and not through a graphical interface and keyboard. For more information about the terminal

device, see

Step

Do not apply power at this time – This system includes a service processor (SP) that is used to configure and boot the main

■

host server. To properly configure the host server and view SP messages, do not apply AC power to the server until the SP and

host networking connections are made, as described in this guide.

Shipping Contents

Quantity

Item

Server

RJ-45 Ethernet cable

RJ-45 to DB-25 adapter (crossover)

RJ-45 to DB-9 adapter (crossover)

Wrist strap

Power cords (packaged separately)

Rackmounting kit with cable management

assembly

Step