A-M Systems 4000 Інструкція з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Підсилювач A-M Systems 4000. A-M Systems 4000 12 сторінок. Multirecord extracellular amplifier
Друкувати сторінку
WARNING
THIS EQUIPMENT IS NOT
INTENDED FOR USE WITH
HUMAN SUBJECTS IN ANY
WAY.
Document
The information contained in this
manual was as accurate as possible
at the time of publishing, but is
subject to change without notice
and should not be construed as a
commitment by A-M Systems.
Changes may have been made to
the hardware or firmware it
describes since publication. A-M
Systems reserves the right to
change specifications as required.
For the latest information please
check our website (http://www.a-
msystems.com) or contact A-M
Systems, directly.
Manual Product Number 980004
Manual Document Number
1027910 Rev 01
All rights reserved. No part of this
document may be reproduced by
any means without the prior written
permission of A-M Systems
Safety
This instrument is provided with
terminal for protective grounding.
Before applying power, verify that
the correct safety precautions are
taken (see the following warnings).
In addition, note the external
markings on the instrument that are
described under Safety
Symbols. Do not operate the
instrument with its cover removed.
Replace fuse only with specified
type.
Supply Voltage
This equipment can be operated
between 100V – 240V, max 0.9A,
and 50-60Hz.
WARNING
Do not attach a line voltage that
does not match the line voltage
specified on the rear panel.
Before turning on the instrument,
you must connect the protective
earth terminal of the instrument to
the protective earth conductor of
the (mains) power cord. The mains
plug must only be inserted in a
socket outlet with a protective earth
contact.
Service should be performed by
trained personnel only. To avoid
dangerous electric shock, do not
perform any service unless
qualified to do so.
Do not operate the instrument in
the presence of flammable gases or
fumes. Operation of any electrical
instrument in such an environment
constitutes a safety hazard.
Safety Symbols
!
The product is marked with this
symbol when it is necessary for you
to refer to the instruction manual in
order to protect against damage to
the product.
WARNING
The Warning symbol calls attention
to a procedure or practice, which, if
not correctly performed could
result in injury. Do not proceed
beyond a Warning symbol until the
indicated conditions are fully
understood and met.
CAUTION
The Caution symbol calls attention
to a procedure or practice, which, if
not correctly performed could
result in damage to the product. Do
not proceed beyond a caution until
the indicated conditions are fully
understood and met.