Fujitsu fi-5220C Початок роботи - Сторінка 10

Переглянути онлайн або завантажити pdf Початок роботи для Сканер Fujitsu fi-5220C. Fujitsu fi-5220C 28 сторінок. Flatbed scanner
Також для Fujitsu fi-5220C: Посібник з інсталяції Посібник з інсталяції (7 сторінок), Посібник з інсталяції Посібник з інсталяції (9 сторінок), Процедури встановлення (3 сторінок), Технічні характеристики (2 сторінок), Посібник для початківців (29 сторінок), Інструкція з експлуатації (13 сторінок), Інструкції з очищення (2 сторінок), Інструкції з очищення (2 сторінок)

Друкувати сторінку
Fujitsu fi-5220C Початок роботи
■ Removable Parts
Parts that can be removed from the scanner are dis-
played below.
Can be
Pick roller
removed
Pad ASSY
[fi-5220C only]
Document cover

1.3 Operator Panel

The operator panel is located on the right side of the
scanner. This panel comprises of a Function Number
display, four buttons and a LED.
2
ADF paper chute
Sheet guide
Function
Number
display
Function
Send to
Scan
Power button
LED
Name
Function Number display
Buttons
Function
Send to
Scan
Power button
LED
-
*) About the settings on the launcher, refer to FUJITSU
TWAIN32 scanner driver help and the "fi-5120C/fi-
5220Cfi-5120C/fi-5220C Operator's Guide" in the Setup
CD-ROM.
■ Indications on the Function
Number Display
No.
8
Lights only one time upon turning on the scanner.
P
Indicates that the scanner has been turned ON and
is being initialized.
0
Indicates that initialization will soon be completed.
1
Indicates that initialization has been completed
successfully.
This status is called "Ready Status".
U
Indicates that a temporary error occurred when
documents were being scanned. A number appear-
ing in alternation following the U (i.e., 1 or 2, etc.)
refers to the type of error.
To return the scanner to the ready status ("1"),
press "Scan" or "Send to" button.
E
Indicates that a device (hardware) alarm has
occurred during scanning of documents.
"E" and the alarm Number (0 to 9, A,c,d and F)
will appear alternately.
To return the scanner to the ready status ("1"),
press "Scan" or "Send to" button.
If this alarm occurs, turn the power off and on
again. If the alarm continues after turning the
power on again, contact your service engineer.
Function
Indicates the function Num-
ber and error status.
Changes the Function acti-
vated by the Send to button
(*).
Launches the linked applica-
tion software (*).
Turns the scanner ON and
OFF.
Lights when the scanner is
turned ON.
Descriptions