Fujitsu fi-7300NX Інструкції із заміни витратних матеріалів та очищення - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкції із заміни витратних матеріалів та очищення для Сканер Fujitsu fi-7300NX. Fujitsu fi-7300NX 27 сторінок. Image scanner
Також для Fujitsu fi-7300NX: Початок роботи (2 сторінок)
Друкувати сторінку
Cleaning the Inside of the Scanner (ADF) with a Cloth
The Inside of the ADF can be cleaned with a piece of cloth moistened with Cleaner F1, or a sheet of Cleaning Wipe.
As the scanner continues to feed the documents, paper dust will accumulate Inside the ADF and it may cause scanning
errors. Cleaning should be performed approximately every 5,000 sheets scanned. Note that this guideline varies
depending on the types of documents you scan. For Instance, it may be necessary to clean the scanner more frequently
when you scan documents on which the toner is not sufficiently fused.
The Inside of the ADF becomes very hot when the scanner is being used.
Before you start cleaning the Inside of the ADF, make sure to turn off the power, unplug the power cable and wait
for at least 15 minutes for the Inside of the ADF to cool down.
ATTENTION
Do not use water or mild detergent to clean the ADF.
It may take a long time to dry if an excessive amount of Cleaner F1 Is used. Use only a small amount. Wipe
off the cleaner completely to leave no residue on the cleaned parts.
1.
Turn off the scanner, unplug the power cable and wait for at least 15 minutes.
2.
Open the ADF.
When the ADF is open. It might close accidentally. Be careful not to get your fingers caught.