Brother DCP-J4110DW Посібник з швидкого налаштування - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з швидкого налаштування для Сервер друку Brother DCP-J4110DW. Brother DCP-J4110DW 27 сторінок. Guia de wi-fi direct
Також для Brother DCP-J4110DW: Посібник (36 сторінок), Посібник (22 сторінок), Посібник з швидкого налаштування (41 сторінок), Посібник з безпеки продукції (25 сторінок), (іспанською) Посібник з веб-підключення Guia De Web Connect (38 сторінок), Посібник (іспанською) (24 сторінок)

Load plain A4 paper

CAUTION

DO NOT carry the machine by holding the scanner

cover, the Jam Clear Cover, the manual feed slot

cover, or the control panel. Doing this may cause

the machine to slip out of your hands. Carry the

machine by sliding your hands into the handhold

indentations located on each side of the machine.

For detailed information, see the Product Safety

Guide.

Pull the paper tray completely out of the

machine.

Open the output paper tray cover.

Gently press and slide the paper guides a to fit

the paper size. Make sure that the triangular

mark b on the paper guide a lines up with the

mark for the paper size you are using.

Fan the stack of paper well to avoid paper jams

and misfeeds.

NOTE

Always make sure that the paper is not curled or

wrinkled.

Gently put the paper into the paper tray print

side down and top edge first.

IMPORTANT

Be careful that you do not push the paper in too

far; it may lift at the back of the tray and cause

paper feed problems.

Gently adjust the paper guides to fit the paper.

Make sure that the paper guides touch the

edges of the paper.

Check that the paper is flat in the tray and

below the maximum paper mark. Close the

output paper tray cover.

Slowly push the paper tray completely into the

machine.