Brother HL-5250DN series Посібник з швидкого налаштування - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з швидкого налаштування для Сервер друку Brother HL-5250DN series. Brother HL-5250DN series 23 сторінки. Laser printer
Також для Brother HL-5250DN series: Посібник з швидкого налаштування (34 сторінок), Брошура та технічні характеристики (4 сторінок), Посібник з монтажу (17 сторінок), Посібник з експлуатації (9 сторінок), Посібник з експлуатації (12 сторінок)
Друкувати сторінку
Regulations
Important
A shielded interface cable should be used in order to
ensure compliance with the limits for a Class B digital
device.
Changes or modifications not expressly approved by
Brother Industries, Ltd. could void the user's authority
to operate the equipment.
Radio interference (220-240 volt model only)
This printer follows EN55022 (CISPR Publication
22)/Class B.
Before you use this product, make sure that you use
one of the following interface cables.
1 A shielded parallel interface cable with twisted-pair
conductors and that it is marked "IEEE 1284
compliant".
2 A USB cable.
The cable must not be more than 2 metres long.
EC Declaration of Conformity
Safety Precautions
IEC 60825-1 specification (220 to 240 volt model
only)
This printer is a Class 1 laser product as defined in
IEC 60825-1 specifications. The label shown below is
attached in countries where it is needed.
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE 1
LASER KLASSE 1 PRODUKT
This printer has a Class 3B laser diode which
produces invisible laser radiation in the scanner unit.
You should not open the scanner unit under any
circumstances.
Caution
Use of controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
Internal laser radiation
Maximum radiation power:
Wave length:
Laser class:
IMPORTANT - For Your Safety
To ensure safe operation, the supplied three-pin plug
must be inserted only into a standard three-pin power
outlet that is properly grounded through the normal
household wiring.
Extension cords used with this printer must be three-
pin plug type and correctly wired to provide proper
grounding. Incorrectly wired extension cords may
cause personal injury and equipment damage.
The fact that the equipment operates satisfactorily
does not imply that the power is grounded and that
the installation is completely safe. For your safety, if
in any doubt about the effective grounding of the
power, call a qualified electrician.
This product should be connected to an AC power
source within the range indicated on the rating label.
DO NOT connect it to a DC power source. If you are
not sure, contact a qualified electrician.
5 mW
770 - 810 nm
Class 3B
3