Brother MFC-J4610DW Посібник із швидкого старту - Сторінка 18

For Wireless Network Users

For wireless network interface users

Although your Brother machine can be used in both a wired and wireless network, only one of the connection

methods can be used at a time.

NOTE

If you have previously configured the wireless settings of the machine you must reset the network settings

before you can configure the wireless settings again.

On your machine, press Settings.

Press s or t to display Network. Press Network.

Press s or t to display Network Reset. Press Network Reset.

Press Yes to accept. Hold down Yes for 2 seconds to confirm.

NOTE

To set up your machine in Ad-hoc mode (connected to a wireless-capable computer without an access

point/router) you can find instructions in the Network User's Guide on the CD-ROM.

You can view the Network User's Guide by following the instructions below.

1 Turn on your computer. Insert the CD-ROM into your CD-ROM drive.

For Windows

2 Choose your model and the language. The CD-ROM top menu will appear.

3 Click User's Guides, and then click PDF documents.

4 Click Network User's Guide.

For Macintosh:

2 Double-click User's Guides. Choose your model and the language.

3 Click User's Guides, and then click Network User's Guide.

Choose your wireless setup method

The following instructions offer three methods for setting up your Brother machine on a wireless network. Choose

the method you prefer for your environment.

Setup using the installation CD-ROM and a USB cable (Windows

You need to temporarily use a USB cable during configuration (cable not included).

It is recommended that you use a computer wirelessly connected to your network for this method.

If you are using Windows

point/router by network cable, you need to know your wireless settings. Please write down your

wireless network settings in the area on page 19.

Now go to

XP, or currently using a computer connected to an access

and Macintosh)

page 20