Fujitsu 9811 ATB Посібник оператора - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник оператора для Принтер Fujitsu 9811 ATB. Fujitsu 9811 ATB 22 сторінки. Printers

Cleaning

It is essential to regularly clean the printer in order to keep it in good operating condition.

Cleaning object

Magnetic head

Print head

Paper dust

How to clean the magnetic head

1.To cleaning magnetic head, please push keys " ON / OFF" and then " 1 " while on-line.

This coupled key usage puts the printer into Cleaning mode.

2.Please insert the cleaning card into the insertion slot. The card is fed into and ejected.

3.Please pull the ejected card out. The mode switches to on-line automatically.

How to clean print head

1. Please remove the ribbon after opening the printer door.

2. Clean the print surface of head with the top of the "cleaner'" and wipe it with a clean cloth.

Also clean the ribbon guide shaft.

*The moistened top of the cleaner can lift the dust from the head and shaft.

*The surface to be cleaned is shown with circles in the photograph.

*Please inspect the surface from under the head.

3.Please install the ribbon again and close printer door. Printer turns to initial on-line mode

Ribbon guide shaft

How to clean paper dust

Use a vacuum cleaner to clean paper dust on the paper path.

Cleaning period or timing

When a ribbon is replaced, or if many

voided encode errors have occurred.

If the printing becomes smeared by dust

on the print head.

If a lot of dust was observed in a paper

path.

Printing surface

Note

The magnetic head needs to be cleaned to remove

grease and dust which will accumulate during

usage.

A dusty environment or a very old ribbon may carry

dust onto the head.

Over time paper dust will accumulate and need to

be removed.

Thermal head cleaner

Operating the Printer