AEG OKO-SANTO 2842-6 i Інструкція з експлуатації та монтажу - Сторінка 15
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та монтажу для Холодильник AEG OKO-SANTO 2842-6 i. AEG OKO-SANTO 2842-6 i 28 сторінок. Integrating fridge freezer
Також для AEG OKO-SANTO 2842-6 i: Інструкція з експлуатації та монтажу (14 сторінок)
Друкувати сторінку
Something Not Working
If the appliance is not functioning correctly, please carry out the fol-
lowing checks before contacting your local AEG Service Force Cen-
tre.
Warning!
Repairs should only be carried out by qualified service engineers.
Repairs carried out by inexperienced persons may cause injury or
serious malfunctioning.
Malfunction
Appliance does not work.
Appliance cools too much.
The food is too warm.
Interior lighting does not
work.
Heavy build up of frost, pos-
sibly also on the door seal.
Possible Cause
Appliance is not switched on Switch on the appliance.
Mains plug is not plugged in
or is loose.
Fuse has blown or is defec-
tive.
Socket is defective.
Temperature is set too cold. Turn the temperature regu-
Temperature is not properly
adjusted.
Door was open for an exten-
ded period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air tight
(possibly after changing
over the hinges).
Remedy
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to be
corrected by an electrician.
lator to a warmer setting
temporarily..
Please look in the "Initial
Start Up" section.
Open the door only as long
as necessary.
Turn the temperature regu-
lator to a colder setting tem-
porarily.
Please see "Installation
location" section.
Please see "Changing the
Light Bulb" section.
Carefully warm the leaking
sections of the door seal
with a hair dryer (not hotter
than approx. 50 ¡C). At the
same time shape the war-
med door seal by hand such
that it sits correctly.
15