AEG OKO-SANTO 3250-6 KG Інструкція з експлуатації Посібник з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Холодильник AEG OKO-SANTO 3250-6 KG. AEG OKO-SANTO 3250-6 KG 12 сторінок. Electrolux fridge freezer operating instructions
Також для AEG OKO-SANTO 3250-6 KG: Інструкція з експлуатації Посібник з експлуатації (24 сторінок)

Друкувати сторінку

Warning! Before disposing of old appliances make them inoperable. Remo-

ve plug from mains, sever the power cable, remove or destroy any snap or

latch closures, to prevent small children being trapped inside.

• Use an authorised disposal site.

Contact your local Council or Enviromental Health Office to see if there are

facilities in your area to recycle the appliance;

Remove Transport Packaging

The appliance and the interior fittings are protected for transport.

• Remove all adhesive tape and packing pieces from the interior of the

appliance.

You can remove any remnants of adhesive using white spirit.

Installation

Electrical Connection

Any electrical work required to install this appliance should be carried

out by a qualified electrician or competent person.

WARNING – THIS APPLIANCE MUST BE EARTHED

The manufacturer declines any liability should these safety measures not

be observed.

Before switching on, make sure the electricity supply voltage is the same as

that indicated on the appliance rating plate. The rating plate is inside, on the

left.

The appliance is supplied with a 13 amp plug fitted. In the event of having

to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362)

fuse must be used.

Important!

The wires in the mains lead are

coloured in accordance with the fol-

lowing code:

Green and Yellow Earth

Blue

Neutral

Brown

Live

As the colours of the wires in the

mains lead of this appliance may not

correspond with the coloured mark-

ings identifying the terminals in your

plug, proceed as follows:

The wire coloured green and yellow must be connected to the terminal

marked with the letter "E" or by the earth symbol or coloured green and yel-

low.

The wire coloured blue must be connected to the terminal marked "N" or

coloured black.

The wire coloured brown must be connected to the terminal marked "L" or

coloured red.

Upon completion there must be no cut, or stray strands of wire present and

the cord clamp must be secure over the outer sheath.

Warning! A cut-off plug inserted into a 13 amp socket is a serious safety

(shock) hazard. Ensure that the cut-off plug is disposed of safely.

GREEN & YELLOW

13 AMP. FUSE

BROWN

BLUE

CORD CLAMP

D207