Brother MFC-J625DW Посібник - Сторінка 9

Configuring your machine for a network

To use the machine in a networked TCP/IP environment, you need to configure its IP address and subnet

mask. The IP address you assign to the print server must be on the same logical network as your host

computers. If it is not, you must properly configure the subnet mask and the gateway address.

An IP address is a series of numbers that identifies each device connected to a network. An IP address

consists of four numbers separated by dots. Each number is between 0 and 255.



Example: In a small network, you would normally change the final number.

• 192.168.1.1

• 192.168.1.2

• 192.168.1.3

How the IP address is assigned to your print server:

If you have a DHCP/BOOTP/RARP server in your network the print server will automatically obtain its IP

address from that server.

Note

On smaller networks, the DHCP server may also be the Router.

For more information on DHCP, BOOTP and RARP, see:

Using DHCP to configure the IP address uu page 14.

Using BOOTP to configure the IP address uu page 15.

Using RARP to configure the IP address uu page 14.

If you do not have a DHCP/BOOTP/RARP server, the Automatic Private IP Addressing (APIPA) protocol will

automatically assign an IP address from the range 169.254.1.0 to 169.254.254.255. For more information on

APIPA, see Using APIPA to configure the IP address uu page 15.