Fujitsu D1837 Технічний посібник - Сторінка 16

Переглянути онлайн або завантажити pdf Технічний посібник для Материнська плата Fujitsu D1837. Fujitsu D1837 48 сторінок. Siemens

Brief instructions on installing mainboard

If you have purchased a separate mainboard, you can install the mainboard in your system in

accordance with the following brief instructions.

The activities described here assume a basic knowledge of PCs and cannot be carried out by a

layperson. If you are not sure whether you have the necessary specialised knowledge, then leave

this work to an expert.

The illustrations of the system show examples of possible cases.

►

Please take note of the safety information in the "Important notes" chapter.

►

Check whether the processor, memory modules and power supply are suitable for this

mainboard:

–

processor (see "Installing and removing processors" chapter).

–

memory modules (see "Upgrading main memory" chapter).

–

power supply (see "Electrical Properties" chapter).

►

Make sure the current requirement of the fans (processor, case) does not exceed the

loadability of the fan connections (see chapter entitled Electrical Properties").

►

First only install the components absolutely necessary (graphics card, processor and heat

sink, one memory module) and only connect the required connections (power supply unit, case

connections such as ATX on/off switch, hard disk or floppy disk drive). You should not install

additional cards and devices until this minimum configuration successfully boots (see chapter

entitled Add-on modules / Upgrading").

Installation

►

Equip the mainboard with the processor, heat sink and memory modules before installation if

possible. Further information can be found in "Installing and removing processors" chapter.

A26361-D1837-Z120-1-7419, Edition 1

►

Open the casing as described in the

operating manual.

English - 7