Indesit LF 70 FR Посібник з експлуатації - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Посудомийна машина Indesit LF 70 FR. Indesit LF 70 FR 29 сторінок.
Друкувати сторінку
5.3. ROD AND SAT TESTING CYCLE:
1.
START OF A LONG TESTING CYCLE
2.
Drain V + 0 sec.
3.
Reading of turbidity sensor and pressure switch in empty state.
3.1. If it read a max turbidity value (clean, connected), it turns on the Rinse Aid led up to the end of
the cycle.
3.2. If it read a min turbidity value (unclean, disconnected), it turns off the Rinse Aid led up to the end
of the cycle.
-
If Rinse Aid led remains off, the turbidity sensor does not work or it is disconnected. Probable
defects: faulty or disconnected turbidity sensor, dirty optical tube, faulty/disconnected Rinse Aid
led.
4.
Salt led switches on simultaneously to Rinse Aid led (up to the end of the cycle)
-
If the Salt led remains off, it does not work
Probable defect: disconnected Salt led, faulty connection.
5.
TURBINE-filling of 2 litres, in static phase + (searching of alternated wash position, washing up + down).
-
if the Timer does not receive any signal from the turbine, but water is filling the tank, once reached
F static (1,2litri), it activates the wash motor and fills up to reach the F dynamic pressure switch,
for a max time of 153 sec. from the activation of the solenoid valve.
Probable defect: faulty or disconnected turbine.
6.
Pause of 10 seconds, checking of HIGH PRESSURE sensor, (it must be off, stand-by position).
-
If H.P. sensor is on, the dw is in filter cleaning alarm.
Probable defect: faulty or disconnected H.P.
7.
WASH MOTOR activation.
8.
TURBINE-filling of 2 litres, in dynamic phase (total 4 lt), (wash motor on).
9.
I Checking pressure switch state (V - P), (wash motor on)
9.1. If it is in F (full), filling phase is finished, the dw only washes
9.2. If it is in E (empty), it fills and wash up to reach F pressure switch or a max quantity equal to 8 lt,
-
If at 8 lt the pressure switch has not still reached F state, the dw is in filter cleaning alarm.
Probable defect: faulty pressure switch, cables disconnected/inverted.
10. WASH MOTOR on, 1 minute of preparation to filling.
-
In case it fills a quantity higher than 8 litres, the dw is in filter cleaning
Probable defect: faulty pressure switch, cables disconnected/inverted.
11. Activation of WASH MOTOR, HEATER, ELECTRO-DISPENSER, (washing up/down) 20".
12. Checking of HIGH PRESSURE sensor 5sec. (it must be on).
-
If high pressure sensor is off, the dw is in filter cleaning alarm.
Probable defect: faulty HP sensor - DECANTER spout clogged.
13. WASH + HEATING 1 minute
14. If the dw has selected Half Load, see point 15.
-
If the dw has selected the alternated wash, see point 16
15. Section about the control of dw with Half Load (no alternated wash)
15.1 Deactivation of wash pump
Service Manual
Seven Digit - 2005
Edition
2005.07.08
G
Language
English
B
15