Indesit 7OIF 617 K.A RU Інструкція з експлуатації Посібник з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Духовка. Indesit 7OIF 617 K.A RU. Indesit 7OIF 617 K.A RU 24 сторінки.
Також для Indesit 7OIF 617 K.A RU: Інструкція з експлуатації Посібник з експлуатації (20 сторінок)

Друкувати сторінку

Indesit 7OIF 617 K.A RU Інструкція з експлуатації Посібник з експлуатації

Fitting the power supply cable

3. Secure the cable by fastening the clamp screw.

4. Close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load

indicated on the data plate (see side).

The appliance must be directly connected to the mains

using an omnipolar circuit-breaker with a minimum contact

opening of 3 mm installed between the appliance and the

mains, suitable for the load indicated and complying with

current electrical regulations (the earthing wire must not be

interrupted by the circuit-breaker). The supply cable must

not come into contact with surfaces with temperatures

higher than 50°C.

! The installer must ensure that the correct electrical

connection has been made and that it is compliant with

safety regulations.

Before connecting to the power supply, make sure that:

• The appliance is earthed and the plug is compliant with

the law.

• The socket can withstand the maximum power of the

appliance, which is indicated on the data plate (see

below).

• The voltage must be in the range between the values

indicated on the data plate (see below).

• The socket is compatible with the plug of the appliance.

If the socket is incompatible with the plug, ask an

authorised technician to replace it. Do not use extension

cords or multiple sockets.

! Once the appliance has been installed, the power supply

cable and the electrical socket must be easily accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced by

authorised technicians only (see Assistance).

! The manufacturer declines any liability should these safety

measures not be observed.

1. Open the terminal board

by inserting a screwdriver into

the side tabs of the cover. Use

the screwdriver as a lever by

pushing it down to open the

cover (see diagram).

2. Install the power supply

cable by loosening the

cable clamp screw and the

three wire contact screws

L-N-

Connect the wires to the

corresponding terminals:

the Blue wire to the terminal

marked (N), the Brown wire

to the terminal marked (L)

and the Yellow/Green wire

to the terminal marked

(see diagram).

APPLIANCE SPECIFICATIONS

width 43.5 cm

Dimensions*

height 32,4 cm

depth 40.6 cm

Volume*

58 l

width 45.5 cm

Dimensions**

height 32,4 cm

depth 40.6 cm

Volume**

60 l

voltage: 220-240V~ 50/60 Hz

Electrical

maximum power absorbed

connections

2800 W

Directive 2002/40/EC on the label of

electric ovens. Standard EN 50304

Energy consumption for Natural

ENERGY

convection – heating mode:

LABEL

Traditional mode

Declared energy consumption for

Forced convection Class – heating

mode: Baking

This appliance conforms to the

following European Economic

Community directives: 2006/95/EEC

dated 12/12/06 (Low Voltage) and

subsequent amendments –

2004/108/EEC dated 03/05/89

(Electromagnetic Compatibility) and

subsequent amendments -

93/68/EEC dated 22/07/93 and

subsequent amendments.

2002/96/EC and subsequent

amendments.

- 1275/2008 standby/off mode

* Only for models with drawn rails.

** Only for models with wire rails.