Indesit KD3C1/G Інструкція з монтажу та використання - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з монтажу та використання для Кухонні плити Indesit KD3C1/G. Indesit KD3C1/G 28 сторінок. 50cm free standing electric cooker
Друкувати сторінку
Installation
WARNING – THIS APPLIANCE MUST BE EARTHED.
Electrical connection
Electric cookers come without a power supply cable. The cooker is designed to operate on an electricity supply which
conforms to the electrical data shown on the Rating Plate. The cooker can be connected to the mains only after removing
the back panel of the cooker itself with a screwdriver.
N.B.: the following installation procedure must be carried out by a qualified electrician. The electrical installation must
comply with the IEE Regulations, Building & local By-Lays.
For the installation of the feeding cable carry out the following operations:
4
1
Open the terminal board by inserting a screwdriver into the side tabs of the
cover. Use the screwdriver as a lever by pushing it down to open the cover (see
diagram).
2
Loosen the cable clamp screw and remove it, using a screwdriver as a lever
(see figure).
3
Remove the wire contact screws L-N-
heads, respecting the colour code: Black/Blue (N), Red/Brown (L) and Bare Wire/
Yellow-Green (
).
l Once the connections have been made, tighten all the terminal screws fully.
l Fasten the supply cable in place with the clamp and close the cover of the
terminal board.
, then fasten the wires under the screw