Indesit WD 12 S Інструкція з монтажу та використання - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу та використання для Пральна машина / сушарка Indesit WD 12 S. Indesit WD 12 S 21 сторінка. Indesit washer-dryer instructions for installation and use

Друкувати сторінку

Here I'm in command

Making the right choice is important. And it's easy.

Programme selector knob

Use this knob to select the wash

programme.

Turn this knob clockwise only.

To select a programme, you

should turn the knob so that the

symbol/number of the desired

programme is in line with the

pointer on the knob.

Now press on/off button H

(position I), pilot lamp I will start

flashing.

After 5", the setting will be

accepted, pilot lamp I will stop

flashing (staying lit) and the wash

cycle will begin.

Should you wish to interrupt the

programme in progress or set a

new one, select one of the

symbols (Stop/Reset) and wait

5" : when the cancellation has

been accepted, pilot lamp I

flashes, and you can then turn the

appliance off.

After the wash cycle has been set

and accepted by the washing

machine, turning the knob will

have no effect (except for when

it is on position

Stop/Reset).

Temperature control knob

It is used to set the wash tempe-

rature in the recommended

programme table on pag. 4. It also

allows you to reduce the tempe-

rature recommended for the

selected programme, and even to

set a cold wash cycle ( ).

Drying cycle knob

Use this knob to select the

desired dr ying cycle. Two

options are available:

A - Based on time:

From 40 minutes to 150.

B - Based on the damp level of

the dry clothes:

Iron

:use this slightly damp

setting for clothes that you

intend to iron to reduce effort

and save energy in the drying

cycle.

Wardrobe

: use this setting

when you want dry clothes that

can be stored after hanging for

a short while.

Extra dry

: use this setting

when you want very dry clothes.

A cooling stage is foreseen at

the end of the drying cycle.

Understanding the control panel

Detergent dispenser

It is divided into three

compartments:

1. Detergent for pre-wash;

2. Detergent for the main cycle

wash;

3. Fabric conditioner.

Anti-crease

This button allows you to

interrupt a programme (on

symbol

) keeping the washing

soaking in water before the spin

cycle. It is a very useful button

in particular because it can be

used

for

delicates

synthetics. It is only to be used

with wash programmes for

synthetic fabrics, silk and

curtains when it is impossible for

you to take the washing out

immediately. Before opening the

washing machine door, finish the

wash cycle as follows:

press button E

and the machine will drain the

water.

press button E

if you want a spin cycle, or turn

knob A to symbol

if you want

the water to be drained.

Slow spin

Use this button to reduce the

spinning speed from 1200 to

600 rpm for the cotton and linen

programmes and from 850 to

600 rpm for the synthetic

fabrics programmes.

Extra Economy

Reduces water consumption

during the rinse cycles. We

recommend that you use this

function only with small laundry

loads, dosing the detergent

proportionally.

On-off

When button H is pressed, the

washer-dryer is switched on,

when it is not the machine is

switched off.

Turning the appliance off

does not cancel the selected

and

programme.

On-off lamp / door locked

Lamp I flashes slowly when the

appliance is switched on and

awaiting instructions and at the

end of a cycle, indicating that the

door can be opened. It flashes

quickly when the door should

not be opened. A steady light

means the appliance has

accepted

the

programme.

Drying cycle lamp

When this lamp is on, it means

that knob C has been set on a

drying cycle and at the end of the

wash cycle, the appliance will run

the selected tumble drying cycle.

selected