Indesit IS67G1PMW/UK Посібник - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник для Варильна поверхня Indesit IS67G1PMW/UK. Indesit IS67G1PMW/UK 21 сторінка.

Друкувати сторінку

WARNING : This operation must be perfomed

by a qualified technician

INSTALLATION

Before operating your new appliance please read

this instruction booklet carefully. It contains

important information concerning the safe installation

and operation of the appliance.

Please keep these operating instructions for future

reference. Make sure that the instructions are kept

with the appliance if it is sold, given away or moved.

The appliance must be installed by a qualified

professional according to the instructions provided.

Any necessary adjustment or maintenance must be

performed after the appliance has been

disconnected from the electricity supply.

The following instructions should be read by a

qualified technician to ensure that the appliance is

installed, regulated and technically serviced

correctly in compliance with current regulations.

Positioning and levelling

It is possible to install the appliance alongside

cupboards whose height does not exceed that of the

hob surface.

This cooker should be installed directly on

. Do not install this cooker on an

the floor

artificial base of any kind.

Make sure that the wall in contact with the back of

the appliance is made from a non-flammable, heat-

resistant material (T 90°C).

Important: Do not install this appliance

adjacent to the door or other means of

access to minimise the likelihood of persons

using the door making contact with pans on

the hob surface.

The appliance must not be installed behind

a decorative door in order to avoid overheating

This appliance must not be fitted on a platform.

The cooker is designed to fit between kitchen cabinets

spaced 600mm apart. The space either side need

only be sufficient to allow withdrawal of the cooker for

servicing. It can be used with cabinets one side or

both as well as in a corner setting. It can also be used

free-standing.

Adjacent side walls which project above hob level,

must not be nearer to the cooker than 150mm or 65mm

and should be protected by heat resistant

material. Any overhanging surface or cooker hood

should not be nearer than 750mm.

a. The cooker may be located in a kitchen, a kitchen/

diner or bed sitting room, but not in a bathroom or

shower room.

b. The hoods must be installed according to the

requirements in the hood handbook.

c. The wall in contact with the back of the cooker must

be of flameproof material.

d. The cooker is fitted with a safety chain that must be

attached to a hook, secured to the wall behind the

appliance.

Before moving your cooker check that it is cool, and switched

off at the cooker control unit. Movement of your cooker is most

easily achieved by lifting the front as follows:

Moving the Cooker

Fig. A

Open the grill door sufficiently to allow a comfortable

grip on the underside front edge of the oven roof,

avoiding any grill elements. (FIG.A)

Take care in moving the cooker as it is heavy. Take care

to ensure that any floor covering is not damaged.

Electrical connection

Power supply voltage and frequency: 230-240V a.c.

50/60 Hz.

The supply cable must be positioned so that it never

reaches at any point a temperature 50°C higher than

the room temperature. The cable must be routed away

from the rear vents. Should you require it, you may

use a longer cable, however, you must ensure that the

cable supplied with the appliance is replaced by one

of the same specifications in accordance with current

standards and legislation.

WARNINGS: THIS APPLIANCE MUST BE

EARTHED.

The cooker must be connected to the mains by a

switched (double pole) cooker outlet correctly fused

with a capacity appropriate to that shown on the

cooker Rating Plate. All electrical wiring from the

consumer unit to the cooker, via the switched double

pole cooker outlet, must be of an acceptable type

and current rating as above.