AEG 7000 Series Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Морозильна камера AEG 7000 Series. AEG 7000 Series 49 сторінок.
Також для AEG 7000 Series: Посібник користувача (32 сторінок), Посібник користувача (44 сторінок), Посібник користувача (32 сторінок), Посібник користувача (28 сторінок), Посібник користувача (36 сторінок)

Друкувати сторінку

• Do not use the appliance before

installing it in the built-in structure

due to safety manner.

• Do not install or use a damaged

appliance.

• Do not install or use the appliance

where the temperature can be less

than 0°C or where it is exposed to the

weather.

• The floor area on which the appliance

is to be installed must be flat, stable,

heat resistant and clean.

• Make sure that there is air circulation

between the appliance and the floor.

• When the appliance is in its

permanent position, check if it is

levelled correctly with the aid of a

spirit level. If it is not, adjust the feet

accordingly.

• Do not install the appliance directly

above a floor drain.

• Do not spray water on the appliance

and do not expose it to excessive

humidity.

• Do not install the appliance where the

appliance door cannot be fully

opened.

• Do not put a closed container to

collect possible water leakage under

the appliance. Contact the Authorised

Service Centre to ensure which

accessories can be used.

2.2 Electrical connection

WARNING!

Risk of fire and electric

shock.

• The appliance must be earthed.

• Always use a correctly installed

shockproof socket.

• Make sure that the parameters on the

rating plate are compatible with the

electrical ratings of the mains power

supply.

• Do not use multi-plug adapters and

extension cables.

• Make sure not to cause damage to

the mains plug and to the mains

cable. Should the mains cable need

to be replaced, this must be carried

out by our Authorised Service Centre.

• Connect the mains plug to the mains

socket only at the end of the

installation. Make sure that there is

access to the mains plug after the

installation.

• Do not touch the mains cable or the

mains plug with wet hands.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

• This appliance is fitted with a 13 A

mains plug. If it is necessary to

change the mains plug fuse, use only

a 13 A ASTA (BS 1362) fuse (UK and

Ireland only).

2.3 Water connection

• Do not cause damage to the water

hoses.

• Before connection to new pipes,

pipes not used for a long time, where

repair work has been carried out or

new devices fitted (water meters, etc.),

let the water flow until it is clean and

clear.

• Ensure that there are no visible water

leaks during and after the first use of

the appliance.

• Do not use an extension hose if the

inlet hose is too short. Contact the

Authorised Service Centre for the

replacement of the inlet hose.

• When unpacking the appliance, It is

possible to see water flowing from the

drain hose. This is due to the testing

of the appliance with the use of water

in the factory.

• You can extend the drain hose to

maximum 400 cm. Contact the

Authorised Service Centre for the

other drain hose and the extension.

• Make sure that there is access to the

tap after the installation.

2.4 Use

WARNING!

Risk of injury, electric shock,

fire, burns or damage to the

appliance.

• Follow the safety instructions on the

detergent packaging.

• Do not put flammable products or

items that are wet with flammable

products in, near or on the appliance.

• Do not wash fabrics which are heavily

soiled with oil, grease or other greasy

substances. It can damage rubber

ENGLISH