Indesit IDCE 845 B Інструкція з експлуатації - Сторінка 14

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Сушарка Indesit IDCE 845 B. Indesit IDCE 845 B 20 сторінок.

Друкувати сторінку

Care and maintenance

Disconnecting the power supply

Disconnect the dryer when not in use or during cleaning

and maintenance operations.

Cleaning the filter after each cycle

The filter is a fundamental component of the dryer: its function

is to collect lint and fluff that form during drying.

Clean the filter once drying is completed, by rinsing it under run-

ning water or cleaning it with a vacuum cleaner. Should the filter

become clogged, the flow of air inside the dryer will be seriously

hampered: drying times becomes longer and more energy is

consumed. Moreover, the dryer may become damaged.

The filter is located in front of the dryer seal (see Picture).

Removing the filter:

Checking the drum after each cycle

Rotate the drum manually to remove smaller items (handker-

chiefs) that could have been left inside the dryer.

Cleaning the drum

Avoid using abrasives, steel wool or stainless steel cleaning

agents to clean the drum.

A coloured film may appear on the stainless steel drum

surface: it may be caused by a combination of water and/or

cleaning agents such as wash-softeners. This coloured film

does not affect the dryer's performance.

Water container

Condenser unit

1. Pull the filter's plastic han-

dle upwards (see Picture).

2. Clean the fluff off the filter

and replace it correctly. En-

sure that the filter is pushed

fully home.

Do not use the dryer unless

the filter has been replaced

in its holder.

Catches

Handle

Emptying the water container after

each cycle

Remove the water container and empty it into a sink or other

suitable drain outlet, then replace it correctly.

Always check the water container and empty it before star-

ting a new drying cycle.

Cleaning the condenser unit

• Remove the condenser (see Picture below) unit regularly

(monthly) and clean off any fluff deposits from the plates

by rinsing it with cold water running on the rear end of the

condenser.

Removing the condenser:

1. Disconnect the dryer from the power supply and open the

door.

2. Open the condenser cover (see Picture below), unlock the

three catches by turning them 90° anti-clockwise, then

pull on the grip to remove the condenser.

3. Clean the surface of the seals and replace the unit with

the arrows pointing upwards, while making sure that the

catches are securely fixed.

Cleaning the tumble dryer

• The external metal, plastic and rubber parts can be clea-

ned with a damp cloth.

• Clean the front air intake grille regularly (every 6 months)

with a vacuum cleaner to remove any lint, fluff or dust

deposits. Furthermore, remove any lint deposits from the

front part of the condenser and from the filter area, using a

vacuum cleaner every so often.

Do not use solvents or abrasives.

Have the dryer checked regularly by authorised technical

personnel in order to ensure that the electrical and mechani-

cal parts work safely (see Assistance).

Filter

Condenser

unit

Air intake

Condenser cover

Tap

Rear

Front