Indesit IS60V Інструкція з експлуатації - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Сушарка Indesit IS60V. Indesit IS60V 12 сторінок. Indesit tumble dryer instruction booklet
Також для Indesit IS60V: Інструкція з експлуатації (12 сторінок)

Друкувати сторінку

Installation

! Keep this instruction booklet on hand in order to

refer to it when necessary. Take it with you when you

move, and, should you sell this appliance or pass it

on to another party, make sure that this booklet is

supplied along with the dryer so that the new owner

may be informed about warnings and suggestions on

how the dryer works.

! Read these instructions carefully; the following

pages contain important information on installation

and suggestions on how the appliance works.

Where to put your dryer

Place your dryer at a distance from gas ranges,

stoves, heaters, or cook tops because flames can

damage the appliance.

If you are going to install the appliance under a

work counter, be sure to leave a 10mm space

between the top and any other objects on or

above the machine and a 15mm space between

the sides and lateral furnishings or walls. This is

to ensure proper air circulation. Make sure that

the back vents are not obstructed.

Make sure you put your dryer in an environment

that is not damp and has proper air circulation

throughout.

Ventilation

The Dryer dries your laundry by drawing in cool, clean

and relatively dry air, heating it, and then

distributing it through the clothes as they are gently

tumbled. For optimum performance, the moist air is

then blown out through a vent tube at the back of the

dryer.

When the dryer is in use, there has to be adequate

ventilation to avoid the back flow of gases into the

room from appliances burning other fuels, including

open fires.

Mobile venting

A vent tube must always be fitted when the dryer is

used in conjunction with Mobile Venting.

The tube must be fitted securely into the back of the

dryer (see Dryer Description). If possible, it is always

best to connect the tube to a permanent

outlet close to the dryer. If permanent installation is

not possible, the dryer will work just as well with the

tube passing through a partly-opened window.

! Ensure that the end of the tube is not directed

toward the air intake vent at the rear of the dryer.

! The vent tube should not exceed 2.4 metres in length

and should be kept free of any possible

accumulation of fluff, lint and water by shaking it out

frequently. Always ensure that the tube is not squashed.

Permanent venting

In conjunction with the vent tube we recommend

using a Wall/Window Vent Kit, available at a retail

location or the nearest Spare Parts Dealer.

Wall mounting

Window mounting

Depending on how often you use your dryer, it is

essential that areas A and B are checked periodically

to remove lint or debris.

The vent tube adaptor must be fitted securely thus

preventing any humid air from being emitted back into

the room.

! The Dryer should not be pushed so far back that the

tube adaptor is pulled out of position or the tube is

squashed or bent.

! The tube should be kept clear of the air intake vent

and kinks or 'U' bends must be avoided as these will

obstruct the tube or trap condensation.

1. Leave an opening in

the wall to the left of the

dryers proposed position.

2. Keep the tube as short

and straight as possible

to prevent condensed

moisture from backing up

into the dryer.

3. Similarly, the duct in

the wall should slope

downwards towards the

outside.

1. With a stacked dryer

the hole in the window

should ideally be made

below the vent.

2. The tube should be

kept as short as possible.